Page 10
Features
Default Setting
When the air conditioner restarts after a power
failure, it will default to the factory settings
(AUTO mode, AUTO fan, 24°C (76°F)). This
may cause inconsistencies on the remote
control and unit panel. Use your remote
control to update the status.
Auto-Restart
In case of power failure, the system will
immediately stop. To restart the unit, press the
ON/OFF button on the remote control. If the
system has an auto restart function, the unit will
restart using the same settings.
Energy Saving Tips
•
DO NOT
set the unit to excessive temperature levels.
• While cooling, close the curtains to avoid direct sunlight.
• Doors and windows should be kept closed to keep cool or warm air in the room.
•
DO NOT
place objects near the air inlet and outlet of the unit.
• Set a timer and use the built-in SLEEP/ECONOMY mode if applicable.
• If you don’t plan to use the unit for a long time, remove the batteries from the remote control.
• Clean the air lter every two weeks.
• Adjust louvers properly and avoid direct airow.
Louver Angle Memory Function
Some models are designed with a louver angle
memory function. When the unit restarts after a
power failure, the angle of the horizontal louvers
will automatically return to the previous position.
The angle of the horizontal louver should not be
set too small as condensation may form and drip
into the machine. To reset the louver, press the
manual button, which will reset the horizontal
louver settings.
Closing curtains during heating also
helps keep the heat in
Doors and windows should be kept
closed
Refrigerant Leak Detection System
In the event of a refrigerant leak, the LCD screen
will display “EC” and the LED indicator light will
ash.
For a detailed explanation of each function,
refer to the Remote Control Manual.
The display panel on the indoor unit can be used to operate the unit in cases when the remote
control has been misplaced or is out of batteries.
Mode indicators light up to signal the following mode settings.
AUTO COOL DRY HEAT(for cooling & heating models only) FAN ONLY
ambient room temperature and the set temperature on the remote controller. The fan speed is
automatically controlled.
Fan speed and Sleep mode.
temperature is not displayed and you cannot adjust the set temperature.
