534273
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
contact area contact area
3V Batterie
CR2032
-52- -53-
-54-
-55-
-56- -57-
-58-
-59- -60-
G/M
Features
Pedometer
Digital motion sensor for speed measurement
Current speed
Target speed training with alarm
Training Timer
Distance
Pedometer
Average speed, maximum speed
Odometer
Calibration of the stride length for walking or running
Pulse
Alarm for maximum heart rate
Target heart rate training with timer and alarm
(Health, fitness, performance and custom)
Maximum heart rate, lowest heart rate, average heart rate
Calories Functions
Calorie and fat burn during exercise
BMI calculation
Fitness Level
Stopwatch
1/100 second with 99 lap times
Countdown Timer
Time functions
Time
Calendar
Alarm
Hourly chime
Miscellaneous
Backlight
Instruction manual
ATTENTION: Consult your doctor before you begin any training
program. Your doctor can help you choose the proper training
intensity and heart rate guidelines for your exercises.
This heart rate wrist watch is not a medical device and should
only be used as a guide for your training.
Scope of delivery
watch
chest belt
3V CR2032 battery
Please read the instruction manual before using the watch.
Please not that there is a section on solutions to possible
problems at end of the manual.
Inserting the batteries into the chest belt
Use a coin to unscrew the battery cover on the back side of the chest
belt and insert the 3V battery with the (+) sign facing up. Screw the
battery compartment cover back into the case.
Wearing the chest belt
Adjust the chest belt so the it fits snugly directly below the chest
muscles. Moisten the contact areas with water or ECG gel (ECG gel
can be purchased at a pharmacy). Ensure that the contact areas
constantly remain in skin contact.
Position the chest belt as per the following illustration.
Setup
Remove the protective film from the display and press and button.
Important notes on the operation of the wrist watch
The watch has 4 different Modes of Operation
Press MODE to select the mode of operation of the watch.
The order of the modes is as follows:
!
time and basic settings (TIME)
!
stop watch (CHRONO)
!
heart rate measurement (HRM)
!
pedometer (PEDO)
!
time (TIME)
Each mode of operation may have several subfeatures.
The subfeatures can always be accessed by pressing SEL.
Light
Briefly press LIGHT to temporarily activate the light.
Time and basic settings (TIME)
The subfeatures of the time mode can be accessed by pressing SEL.
time and basic settings (TIME) > alarm (ALARM) > timer (TIMER)
Press and hold SET for 3 seconds to access setting mode.
The 12 or 24 hour display will flash.
Press SEL to select 12 or 24 hour mode and press SET to confirm
your setting. Set the seconds, minutes, hours, year, month and day in
the same way.
Now the basic settings will follow. First the year of the birthday setting
will appear (BIRTHDAY).
Press SEL to set the year and press SET to confirm your setting. Set
the month and day in the same way.
Now the weight display will appear (WEIGHT). Set the digits of your
weight by pressing SEL and confirm each digit by pressing SET.
Now the height display will appear (HEIGHT). Set each digit of your
height by pressing SEL and confirm each digit by pressing SET.
Exit setting mode by pressing MODE.
Second time zone
Press and hold SEL for 3 seconds. The watch will switch to the
second time zone display and T2 will appear on the display. Setting
the second time zone can be accomplished in the same way as
described in the previous paragraph.
Press and hold SEL for 3 seconds to return to normal time mode.
Alarm (ALARM)
Press and hold SET for 3 seconds to enter setting mode.
The minutes of the alarm time will blink on the display.
Press SEL to set the minutes and press SET to confirm your setting.
Set the hours in the same way.
You may optionally set the month and day as well.
If neither month nor day are set the alarm will sound daily. If the day
is set, the alarm will sound monthly. If both the month and the day are
set the alarm will sound only at the set date.
The hourly chime setting will now appear on the display (CHIME).
Press SEL to select the setting and confirm your selection by
pressing SET.
If the alarm is activated, the bell symbol will appear and the watch will
chime at the beginning of every hour.
Exit setting mode by pressing MODE.
The alarm can be activated or deactivated by pressing SET. If the
alarm is activated the alarm symbol )) will appear.
When the alarm sounds, press SET, SEL or MODE to stop the alarm.
Timer (TIMER)
Press and hold SET for 3 seconds to enter setting mode.
The minutes of the timer time will appear on the display.
Press SEL to set minutes of the timer time and confirm your setting
by pressing SET. Set the hours in the same way.
Now the additional settings for the timer will follow. Press SEL to
select the desired mode:
Cd r After reaching 0:00 the timer will count the set time again.
Cd U After reaching 0:00 the timer will count forward
Cd S After reaching 0:00 the timer will stop
Exit setting mode by pressing MODE.
The timer can be started or stopped by pressing SET.
Press and hold SET to reset the timer.
After the timer time is up an alarm will sound.
Stop watch (CHRONO)
Press SEL to select the subfeatures of the stop watch
Stop watch (CHRONO) > Memory (DATA RECALL)
Please note: The memory feature can only be used if at least 1 lap
time was recorded.
Press SET to start or stop the stop watch. Press SEL while the stop
watch is running to record a lap time. Up to 99 lap times can be
recorded.
Press and hold SET to reset the stop watch.
Memory mode (DATA RECALL)
The display will show the fastest lap. Press SET to view the other lap
times.
Heart rate measurement (HRM)
Press SEL to select the subfeatures of the heart rate measurement
mode.
Timer (TIMER) > memory (MEMORY) > target heart rate (ZONE) >
calorie burn and fat burn (CALORIE) > speed (PEDO) > fitness
(FITNESS LEVEL)
The subfeatures of the heart rate measurement can only be used
when the chest belt is connected.
While wearing the chest belt, the middle row of the display will show
the current heart rate.
To the right of the heart rate the heart rate in percent of the maximum
heart rate is shown. The maximum heart rate is calculated by
evaluating your age, weight and height.
Timer (TIMER)
The bottom row of the display will show the elapsed training time.
The middle row will show your heart rate and the heart rate in percent
of the maximum heart rate.
The timer will start automatically when the chest belt starts measuring
the heart rate. The timer will continue counting the time if the feature
mode of the watch is changed.
Press SET to select the timer mode:
TIMER total training time
training time in heart rate target zone
training time with heart rate over target zone
training time with heart rate below target zone
Press and hold SET to reset the training time.
Memory feature (MEMORY)
The stored values are shown in the bottom row of the display.
HI maximum heart rate during training
LO minimum heart rate during training
AV average heart rate during training
Press and hold SET to reset the values.
Target heart rate (ZONE)
The bottom row of the display will show the lower and upper limit
value of the target tone.
The selected training type is shown on the top row of the display.
L- U user defined
1 Health
2 Fitness
3 Performance
Press and hold SET for 3 seconds to enter setting mode.
Select the training type by pressing SEL. If "U" is selected (user
defined) the lower and upper limits can be set. Press SET. The
display will show the lower limit.
Set the value by pressing SEL and confirm your setting by pressing
SET.
Set the upper limit in the same way.
Exit setting mode by pressing MODE.
Press and hold SEL to activate the heart rate alarm. If the heart rate
alarm is activated the alarm symbol will appear on the display and an
alarm will sound when the measured heart rate is not within the target
zone.
If your heart rate reaches or exceeds 99% of the maximum pulse a
continuous alarm will sound. This alarm is independent of the set
training zones and the alarm of the training zone.
G/M G/M
G/M G/M
G/M G/M
G/M
G/M
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Inter-Quartz 1-LD2580 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Inter-Quartz 1-LD2580 in de taal/talen: Duits, Engels, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 0,4 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Inter-Quartz 1-LD2580

Inter-Quartz 1-LD2580 Gebruiksaanwijzing - Nederlands, Français - 10 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info