Step 16: Take one pulley out of
the Floating Pulley Plates and hang
the Plates over the Upper Cable
loop. Reinstall the pulley that was
removed.
Attach the Middle Cable (eyelet) to
the Top Beam Plate (on the side
opposite where you want the low
pulley) using the M10 x 105 bolt
from Step 7 (put a washer on each
side of the cable loop end).
Route the Middle Cable down
between Pulley 13 and the retainer
pin, under Pulley 19 in the Floating
Pulley Bracket and up between
Pulley 12 and the retainer pin.
Now go up over the lower pulley in
the Floating Pulley Plates.
Step 16 cont.: Remove the L
bracket in the Adjustable Floating
Pulley Bracket. Insert the cable
end in the Bracket as shown in
the circle and place the Cable
Adapter on the cable end.
Secure with the L bracket.
Tighten L bracket now.
Tighten Top Beam Bolt with
cable end now.
Note: Cable end must be attached to
the Top Beam Plate opposite of the
side you want the Low Pulley. If you
have the Leg Press Option, it will be on
the same side as the Leg Press!!
