Handleiding Indesit ITW E 71252 (pagina 6 van 12) (Nederlands, Engels, Italiaans, Spaans)

577085

Verklein

Vergroot

Pagina terug

1/12

Pagina verder

“Extra Rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with very soft

water, washing baby linen and helping people with allergies.

“Soil Level” button

• Adapts the programme duration to the soil level of your

laundry. Also influences the detergent quantity.

=lightly soiled - =normaly soiled - =heavily soiled.

• Not all soil levels are selectable for each programme.

“Spin Speed/ Rinse Hold” button

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If you select spin speed “0”, the final spinning is cancelled and

the water is drained out only. However, intermediate spin

phases remain during the rinse.

• If you select “Rinse hold”, the laundry remains in the last

rinse water without progressing to the final spin cycle,

to avoid creasing and prevent colours from changing. To

activate the “Rinse hold”, press the “Spin” button repeatedly

until the “Rinse hold” symbol on the display lights up.

- The wash programme stops to “Rinse hold” when the “Rinse

hold” symbol on the display blinks; the light of “Start/

Pause” button also blinks.

- To terminate the “Rinse hold” by spinning the laundry, press

“Start/Pause” - the laundry will be spun with the default

spin speed. You can also select another spin speed with the

“Spin” button before you start the spin cycle by pressing

“Start/Pause”.

- To terminate the “Rinse hold” by draining the water without

spinning, press the “Spin” button until spin speed “0” appears

on the display; then press “Start/Pause” to start the

draining. Do not leave the laundry to soak for too long in the

“Rinse hodl” (especially silk).

“Energy Saver” button

• Saves energy used for water heating while maintaining good

wash result.

• Recomentable for lightly soiled laundry without stains.

• Make sure that your detergent is suitable for cold wash

temperatures (15 or 20 °C).

• Mainly selectable on the lowest temperature step of the

programmes.

“Time Saver” button

• Enables quicker washing by shortening the programme

duration.

• Recommendable for small loads or only lightly soiled

laundry.

DELAY TIMER

The “Delay Timer” button allows the user to run the machine

at his convenience, for example at night when electricity is

cheaper.

• Do not use liquid detergent when activating this function.

• Select programme, spin speed and options.

• Press the “Delay Timer” button several times to select a

delay time by 1 to 23 hours.

• Start the programme (see “Progremme Start”). The

indication lamp over the “Delay Timer” button lights up and

goes off when the programme starts.

• Once having pressed the “Start/Pause” button, the

countdown of the time delay begins. The time delay

indication on the display disappears when the programme

starts and is replaced by the remaining time.

• After the “Start/Pause” button has been pressed, the

number of hours preselected can be reduced by pressing

again the “Delay Timer” button.

To cancel the “Delay Timer”

..before you press the “Start/Pause” button:

• Turn the programme selector to another position or press

the “Reset/Drain” button.

..after having pressed the “Start/Pause” button:

• Press the “Reset/Drain” button for at least 3 second. The

start delay indicator light goes off.

PROGRAMME START

Open the tap and press the “Start/Pause” button. The

blinking light next to the “Start/Pause” button becomes

constant. The programme sequence indicator shows the

current programme phase, running from left to right through

Wash, Rinse, Spin/Drain. When the programme phrase is

finised, the corresponding indication goes out.

“DOOR LOCKED” INDICATION

After start of a program the lamp lights up to indicate that the

lid can not be opened. As long as a wash programme is running,

the lid remains locked and must on no account be forced open.

In case you have an urgent need to open it during a running

programme, refer to “Cancel a running programme before the

end”.

CHILD LOCK BUTTONS

You can lock the buttons of the control panel against improper

use (e.g. by children).

• Press both of the child lock buttons simultaneously and hold

them for at least 3 seconds. The key symbol on the display

lights up.

• To unlock the buttons again: proceed in the same way.

PREPARATION OF THE WASH CYCLE

Load the washing machine, close the drum door and check

that it is closed properly.

2. Pour in the detergent and any additives, as described

overleaf and in the instruction manual.

3. Close the lid.

4. Turn the programme selector to the desired programme.

The display shows the duration of the selected programme

(in hours and minutes), and the indicator for the “Start/

Pause” button flashes. The temperature and spin speed

can be changed by pressing the “Temperature” and

“Spin Speed/ Rinse Hold” buttons. After the end of a

programme, or when a programme is selected but not

yet started, the washing machine will therefore switch off

automatically after about a quarter of an hour. To switch the

washing machine on again, turn the programme selector to

“Off” and afterwards to the desired programme again

SELECT ANY DESIRED OPTION

When the combination of programme and additional option(s)

is not possible, the indication lights switch off automatically.

Unsuitable combinations of options are deselected

automatically.

“Easy Ironing” button

• Reduces creasing by an increased water quantity and a very

gentle spin.

“Prewash” button

• Only for heavily soiled loads (for example sand, granular

dirt) sensible. Increases the cycle time by approximately 15

min.

• Do not use liquid detergent for the main wash when

activating the Prewash option.

FAILURE INDICATIONS

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for Use.

“Water tap closed” -

No or not sufficient inlet water.

“Service” -

Failure or malfunction of an electrical component.

“Clean pump” -

Waste water is not pumped out.

Spin speed on display blinks: unbalance during

spinning

•

PROGRAMME END

The “Door locked” indication lights off and the display

shows “End”. After about a quarter of an hour, the washing

machine will switch off completely to save energy.

1. Turn the programme selector to the “Off” position.

2. Close the water tap.

3. Open lid and drum and unload the machine.

4. Leave the lid open for some time to allow the interior of the

machine to dry.

DETERGENT OVERDOSAGE INDICATION

The symbol will light up at the end of the programme if you

used too much detergent. use less detergent next time. If the

symbol lights up and the display shows “Fod”, too much foam

interrupted the wash process; refer to the “Troubleshooting

Guide” in your Instructions for use.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

Press the “Start/Pause” button to pause the programme.

The light blinks.

2. Select the new programme, temperature, any options and

another spin speed if you want.

3. Press the “Start/Pause” button again. The new programme

continues at the same position where the previous

programme was interrupted. Do not add detergent for this

programme.

CANCEL A RUNNING PROGRAMME BEFORE THE

END

The “Reset/Drain” button cancels a programme before the

end.

• Press the “Reset/Drain” button for at least 3 seconds. The

water is drained out; it may last a while until you can open

the lid.

Programme

Tempe-

rature

(°C)

Load

(kg)

Water

(l)

Energy

without “Time Saver”

(kWh)

Approx. Programme Duration (hrs : min)

without “Time Saver” with “Time Saver”

Cotton 95 7.0 58* 2.10 2:35 2:00

Cotton 60 7.0 52 1.33 2:30 1:45

Cotton 40 7.0 52 0.80 2:25 1:30

Eco Cotton ** 60 7.0 50 1.05 3:40 -

53Eco Cotton ** 60 3.5 35 0.84 2:45 -

Eco Cotton ** 40 3.5 35 0.65 2:00 -

Synthetics 60 3.0 50* 0.90 2:05 1:14

Synthetics 40 3.0 40 0.50 1:50 0:59

Delicate 40 1.5 50 0.55 0:45 -

Delicate 30 1.5 50 0.50 0:41 -

Wool 40 1.0 40 0.55 0:35 -

Wool 20 1.0 40 0.10 0:30 -

Mix Colored 40 3.0 40 0.45 1:00 - 61

Jeans 40 4.0 52 0.58 1:30 1:10

Home Mix 60 3.5 55 1.10 2:00 -

New Born 60 4.0 57 0.90 1:30 1:10

15’ Refresh 30 3.0 30 0.15 0:15 -

Express 30 30 3.0 42 0.25 0:30 -

Mini & Fast 30 1.0 25 0.22 0:45 -

CONSUMPTION DATA

Power consumption in off-mode 0.11 W / in left-on mode 0.11 W

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect

to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer to the

default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

Approximete remaining moisture content (%). After programme end and spinning with maximum selectable spin speed, in default programme setting.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

** Reference Programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

Indesit ITW E 71252 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Indesit ITW E 71252

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info