Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.
■ Memory channel programming
22
6
MEMORY OPERATION
D Programming in memory mode
q Select the desired memory channel with [UP Y] or
[Z DN] in memory mode.
•“BLANK” appears if the selected memory channel is a
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
• To program a blank channel, use direct frequency entry
with the keypad in advance.
e Push [MW] for 2 sec. to program the displayed fre-
quency and operating mode into the memory
channel.
• Preamp setting, attenuator on/off, antenna selection,
and AGC setting can also be programmed into a mem-
ory channel.
[EXAMPLE]: Programming 21.280 MHz/CW into
memory channel 18.
D Programming in VFO mode
q Set the desired frequency and operating mode in
VFO mode.
w Push [UP Y] or [Z DN] several times to select the
desired memory channel.
•“BLANK” appears if the selected memory channel is a
blank channel (and does not have contents).
e Push [MW] for 2 sec. to program the displayed fre-
quency and operating mode into the memory
channel.
• Preamp setting, attenuator on/off, antenna selection,
and AGC setting can also be programmed into a mem-
ory channel.
[EXAMPLE]: Programming 7.088 MHz/LSB into
memory channel 12.
