38
5
RECEIVE AND TRANSMIT
■ Connections for CW
Before operating in CW, select the paddle type using
the SSB/CW set mode.
q Push [SSB/CW] to select CW mode.
•“CW” indicator appears.
w Push [SET] then [SSB/CW] to enter the SSB/CW
set mode.
e Push [DN ▼] or [▲ UP] to select the paddle type
item.
•“PAddLE” is displayed.
r Rotate the tuning dial to select the paddle type.
• Push [M-CL 5] for 1 sec. to return to the default setting.
t Push [SSB/CW] to exit the SSB/CW set mode.
■ CW mode operation
q Connect a paddle or straight key as above.
w Push [M/S•BAND] to select the desired frequency
band.
e Push [SSB/CW] to select CW mode.
• Push [SSB/CW] for 1 sec. to select CW narrow mode
after the CW mode selection when the optional CW nar-
row filter, FL-132 (for MAIN band) or FL-133 (for SUB
band), is installed.
r Rotate the tuning dial to set the operating fre-
quency.
t Push [TRANSMIT] to set the transceiver to transmit
mode.
• The MAIN band indicator lights red.
y Operate the paddle or key to transmit the CW sig-
nal.
u Push [TRANSMIT] to return to receive mode.
CW
Paddle
Straight key
Microphone
[KEY] jack
[MIC] connector
CW paddle with normal polarity (default)
CW paddle with reverse polarity
CW paddle use as bug-key
Electronic keyer OFF (straight key)
Substitute paddle function
(microphone [UP]/[DN])
NOTE: A stereo plug must be used even when a
straight key is used. See page 12 or 15.
NOTE: [UP]/[DN] keying does not function while
pushing [PTT] on the microphone. Push [TRANS-
MIT] on the front panel or use the semi break-in
function in this case.
