7
2
PANEL DESCRIPTION
•Enters numeral “1” when entering an operating
frequency. (p. 23)
•Switches between VFO and memory mode.
(p. 40)
Enters numeral “2” when entering an operating
frequency. (p. 23)
•Enters numeral “3” when entering an operating
frequency. (p. 23)
•Switches between VFO A and B during VFO
mode operation. (p. 21)
Enters numeral “4” when entering an operating
frequency. (p. 23)
Enters numeral “5” when entering an operating
frequency. (p. 23)
Enters numeral “6” when entering an operating
frequency. (p. 23)
Enters numeral “7” when entering an operating
frequency. (p. 23)
•Enters numeral “8” when entering an operating
frequency. (p. 23)
•Stores the displayed operating conditions into
MEMO PAD channel (p. 44)
•Enters numeral “9” when entering an operating
frequency. (p. 23)
•Re-calls the contents in the MEMO PAD channel.
(p. 44)
•Enters decimal point “.” for entering below the
“MHz“ digits when entering an operating fre-
quency.
• Starts and cancels scanning function. (p. 46)
•Turns OFF the SUB band frequency indication
during satellite operation. In this case, only the
MAIN band frequency can be tuned by rotating
the tuning dial. (p. 49)
•Enters numeral “0” when entering an operating
frequency. (p. 23)
•Switches sweep function for the bandscope ON
and OFF. (p. 29)
•Turns OFF the MAIN band frequency indication
during satellite operation. In this case, only the
SUB band frequency can be tuned by rotating
the tuning dial. (p. 49)
Enables operating frequency entering from the
keypad. See page 23 for details.
Equalizes the condition of the VFO A and B.
(p. 21)
Shows 10 Hz and 1 Hz digits of operating fre-
quency on both the MAIN and SUB bands while
pushing and holding. (p. 22)
Stores the set conditions into a memory channel.
(p. 41)
Clears stored contents of memory channel to be
a blank channel. (p. 43)
Transfers the contents of a memory channel into
either the VFO A or B. (p. 42)
Opens squelch for monitoring the operating or
transmit frequency, and the frequency indication
automatically changes to transmit frequency in the
case of duplex or split operation. (p. 34)
Starts and cancels tone scan when the repeater
tone or tone squelch is activated in FM (narrow)
operation. (p. 47)
Used to change memory channel during memory
mode operation by rotating the tuning dial while
pushing and holding. (p. 40)
Switch Switch action when pushed Switch action when pushed for 1 sec.
