1-8
■ Front panel (continued)
%7 MEMO PAD-WRITE SWITCH [MP-W] (p. 8-7)
Programs the selected readout frequency and op-
erating mode into a memo pad.
• The 5 most recent entries remain in memo pads.
• The memo pad capacity can be expanded from 5 to 10
in set mode. (p. 12-16)
%8 VFO/MEMORY SWITCH [V/M]
➥ Switches the selected readout operating mode
between the VFO and memory when pushed.
(pgs. 3-3, 8-2)
➥ Transfers the memory contents to VFO when
pushed for 1 sec. (p. 5-5)
%9 KEYPAD
➥ Pushing a key selects the operating band.
• [GENE•.] selects the general coverage band.
➥ Pushing the same key 2 or 3 times calls up other
stacked frequencies in the band. (p. 3-4)
• Icom’s triple band stacking register memorizes 3 fre-
quencies in each band.
➥ After pushing [F-INP•ENT], enters a frequency or
memory channel. Pushing [F-INP•ENT] or [Y/[Z]
is necessary to end. (pgs. 3-5, 8-2)
• e.g. to enter 14.195 MHz, push [F-INP] [1.8•1] [10•4]
[GENE •] [1.8•1] [28•9] [14•5] [F-INP•
ENT].
^0 MEMORY WRITE SWITCH [MW] (p. 8-4)
Stores the selected readout frequency and operat-
ing mode into the displayed memory channel when
pushed for 1 sec.
• This function is available both in VFO and memory
modes.
^1 MEMO PAD-READ SWITCH [MP-R] (p. 8-7)
Each push calls up a frequency and operating mode
in a memo pad. The 5 (or 10) most recently pro-
grammed frequencies and operating modes can be
recalled, starting from the most recent.
• The memo pad capacity can be expanded from 5 to 10
in set mode. (p. 12-16)
^2
FILTER SWITCH [FILTER] (for MAIN band; p. 5-13)
^3 FILTER SWITCH [FILTER] (for SUB band; p. 5-13)
➥ Selects one of 3 IF filter settings.
➥ Enters the filter set screen when pushed for
1 sec.
^4 AUDIO PEAK FILTER/TWIN PEAK FILTER
SWITCH [APF/TPF] (for MAIN band)
^5 AUDIO PEAK FILTER/TWIN PEAK FILTER
SWITCH [APF/TPF] (for SUB band)
➥ Push to turn the audio peak filter ON and OFF
during CW mode operation. (p. 4-6)
➥ Push to turn the twin peak filter ON and OFF dur-
ing RTTY mode operation. (p. 4-14)
• “ ” appears when audio peak filter is in use.
• “ ” appears when twin peak filter is in use.
➥ During CW mode operation, push for 1 sec. to
select the APF passband width from 80, 160 and
320 Hz. (p. 4-6)
TPF
APF
1
PANEL DESCRIPTION
