71
12
DIGITAL MODE OPERATION
DD
Message Transmission
Select the Message transmission function ON and OFF.
When ON is selected, transceiver transmits a text message
(pre-programmed).
(default: OFF)
After the manual transmission (pushing [PTT]), the Message
Transmission setting is return to OFF automatically.
DD
TX message
TX messages are available up to 6 channels and each chan-
nel can be programmed up to 20 characters message. Avail-
able characters are 0 to 9, A to Z (capital letters only), some
symbols and space. (shown at right table)
DD
TX message programming
A TX message channel C1 must be programmed, if you want
to use the GPS message. The GPS message is transmitted
from channel C1 only.
q Push [MONI] (or [SET]) to edit for 1 sec. then rotate
[DIAL] to select the message channel.
• One of either “C1” to “C6” flashes.
w Push [MONI] (or [SET]) to set into message programming
condition.
• The 1st digit blinks and channel indication stops blinking.
e Rotate [DIAL] to set the desired character.
r Push [MONI] (or [SET]) to select 2nd digit, then rotate
[DIAL] to set the desired character.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming.
t Push [V/MHz] to set the message.
y Repeat steps w to t to set another message channels.
u
Push any key other than indicated function keys to exit the
option set mode.
