19
Chapter 6 – Replacing Filters
Chapter 6 – Replacing Filters
The IQAir system is equipped with a Filter Life Monitor which is designed to assist you in determining when a lter
needs to be replaced. If the air pollution in your environment is very high, there is a possibility that the lter may not
be effective throughout the displayed life time and may have to be replaced earlier than indicated by the Filter Life
Monitor.
For this reason, it is important to look out for the signs of expired lters and replace lters earlier if necessary.
The main signs are:
• Increased operating noise
• Decreased airow
• Clogged lters
• Increased odor presence
Note: After a filter has been replaced, the filter life must be reset in the control panel. Refer to section 4.4.8.
6.1 Location of the Filters
The IQAir system features a modular housing design which enables easy replacement
of all lters in a matter of minutes. The illustration of the IQAir system on the control
panel shows the positions of the individual lters. These positions correspond to the
actual positions of the lters within the system.
5.3 Replacing the Battery of the Remote Control
When the battery becomes weak, the transmission results will deteriorate and the
battery should be replaced. The remote control requires one CR2025 battery. The battery
compartment is located at the bottom end of the remote control.
To open the battery compartment, press the small lever to the side and slide the battery
compartment out. Remove the used battery and insert the new battery.
6.2 Ordering Replacement Filters
To order replacement lters, please contact your local IQAir authorized dealer. To locate the dealer nearest to you,
call 877-400-1050 or visit www.iqair.com.
Please order your replacement lters by quoting the appropriate article numbers stated below:
Pre-Filter Art. No. 102 15 10 00
HyperHEPA Filter Art. No. 102 15 13 00
Filter positions as shown on
the control panel
Battery compartment
(Battery type: CR2025)
HyperHEPA
Pre-Filter
