571940
50
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
50
InstallatIon Manual
Legislation
If the insert is to be mounted in a newly built, non-approved open fireplace, all legal requirements and
local building regulations must be observed. It would always be advantageous to consult your chimney
sweep before mounting the insert.
Room requirements
There must be a constant supply of fresh air to the room in which the insert is to be installed. A window
that opens or an adjustable air vent should suffice.
Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes
be treated as a flammable wall, in which case we ask you to contact your local chimney sweep or glass
producer to hear at what distance the insert should be kept from glass.
Distance to inflammable materials
Please refer to local building regulations to determine the size of the fireproof area in front of the
fireplace.
The insert must be positioned at least 30 cm above the floor if the floor is made of flammable material.
If inflammable material is located near the brickwork casing, there must be a minimum of 40 mm of non-
flammable insulation (fire batt) between the casing and inflammable material. This applies to all of the
casing’s surfaces. The thermal conductivity of the insulation must be less than 0.09 W/m x K (as measured
at 200 ºC); i.e., thermal conductivity must be lower than 0.09 W/m x K.
Chimney requirements
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems.
Nominal draft: approx. 12 Pa.
The chimney must have a minimum opening equivalent to Ø 150 mm.
The chimney opening should always be at least the size of the outlet socket of the insert.
The chimney must have an easily accessible soot door.
Chimney
The chimney is the “motor” of the insert and it is crucial for the functioning of the woodburning insert.
The chimney draft provides a partial vacuum in the insert. This vacuum removes the smoke from the
insert, sucks air through the dampers for the so-called glass pane rinse which keeps the glass free of soot,
and sucks in air through both primary and secondary dampers for the combustion.
The chimney draft is created by the differences in temperature inside and outside the chimney. The
higher the temperature within the chimney, the better the draft. It is crucial, therefore, that the chimney
is warmed through properly before closing the damper and limiting the combustion in the insert (a brick
chimney takes longer to warm through than a steel chimney).
On days where the weather and wind conditions create insufficient draught inside the chimney, it is even
more important to warm up the chimney as quickly as possible. The trick is to quickly get some flames
going. Split the wood into extra fine pieces, use an extra firelighter, etc.
If the stove has not been used for a longer period, it is important to check that the chimney pipe is not
blocked.
englIsh
50

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hwam I30-65 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hwam I30-65 in de taal/talen: Duits, Engels, Deens, Zweeds, Noors als bijlage per email.

De handleiding is 1,92 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Hwam I30-65

Hwam I30-65 Gebruiksaanwijzing - Nederlands, Français, Italiano, Espanõl - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info