Page 13 of 20 pages
stove and secure it with the three screws.
10. Installing the front of the heat storage compartment (12). Put the front of the heat storage compart
-
ment in place and tighten the 2 screws (13) at the top of the front and the 2 screws (14) on each side
of the front.
11. Installing the top plate of the stove (8). Place the top plate (8) on the fittings and secure it with the
two screws (9).
12. Installing the internal heat shield (6). Replace the heat shield (6) at the back of the stove.
13. Installing the rear plate (3). Place the rear plate (3) on the guide pins at the back of the bottom plate
of the stove; then press it in towards the stove. Lift the rear plate and press it lightly inwards until it
engages with the guide pins.
14. Installing the external heat shield (1). Replace the heat shield (1) at the back of the stove.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel chimney on
top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of smoke flue (Drawing B and C)
B: Top smoke outlet
C: Rear smoke outlet
• Steel chimney (9).
• Flue gas elbow (10). Fits into smoke flue socket.
• Brick-built jamb of flue (11).
• Built-in pipe sleeve (12). Fits smoke flue.
• Wall rosette (13). Covers disruption to wall around pipe sleeve.
• Joint (14). Sealed with packing material.
• Smoke outlets (15) of the HWAM stove.
• Smoke flue regulating damper (16).
• Soot door (17).
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly. Check that all insula-
tion plates of the combustion chamber have been properly placed, i.e. that the bottom plate is horizontal
and that the side plates are vertical and reach all the way up to the steel sides of the combustion chamber
and down to the bottom plate.
Vertical cross-section of the stoves (Drawing B):
• The smoke shelf (5). To be placed on top of the steel rail and on the holders in the sides.
• Two-piece smoke defector plate (6). Each half is hung on the hooks located beneath the top plate. The two
halves join in the holders (7) behind the air pipe. Once the stove has been installed, twist the protection
off the two hooks by using pliers or a screwdriver.
• Removable rear plate (2a), covering HWAM
®
Autopilot™. This must always be mounted if the stove
is placed next to a combustible wall.
• Removable external heat shield (2b). This must always be mounted if the stove is placed next to a
combustible wall.
• Removable internal heat shield (2c). This must always be mounted if the stove is placed next to a
combustible wall.
• Loose heat shield (8) under the ash pan. This can be used as a lid when the ash pan is removed for
emptying.
