• Put the charging station in an area with good
airflow.
• Put the charging station in an area with protection
from the sun.
• Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
mains cable to the power outlet.
CAUTION: Do not install the charging
station where there are metal objects
in the ground. Metal objects can cause
interference with the charging station signal.
3.6 To examine where to install the
objects on the map
CAUTION: If the work area is adjacent
to water bodies, slopes, precipices or a
public road, the virtual boundary must have
a protective wall. The wall must be minimum
15 cm / 6 in. in height.
CAUTION: Do not let the product
operate on gravel.
CAUTION: For careful operation
without noise, isolate all obstacles such as
trees, roots and stones.
Note: Make a blueprint of the work area before you
install the virtual boundaries.
• Make sure that the product can receive radio
signals from the reference station in all parts of the
work area.
Note: The maximum distance decreases if there
are objects between the reference station and
product.
• Husqvarna recommends a maximum distance from
the charging station to the most remote part of
the installation. The maximum distance is 1000 m /
3280 ft.
Note: The maximum distance decreases if there
are slopes and high grass.
3.6.1 To install map objects near buildings
and trees
• Make sure that 90° section of the sky is
unimpeded.
Note: Trees or a group of trees with tree
canopies that are more than 4 m / 13 ft. in diameter
(A) can cause temporary stops for the product.
Smaller trees do usually not cause interference
with the operation of the product.
16 - Installation 1691 - 007 - 22.12.2023
