Message Cause Action
Wheel motor
blocked, left/right
Grass or other object is wrapped around the
drive wheel.
Clean the wheels and around the wheels.
Wheel motor overloa-
ded, left/right
Wheel drive problem,
right/left
Cutting system
blocked
Grass or other object is wrapped around the
drive wheel.
Clean the wheels and around the wheels.
The blade disc lies in a pool of water. Move the product and prevent the collection
of water in the work area.
The grass is too high. Cut the grass before you install the product.
Make sure that the grass is maximum 10
cm / 3.9 in.
Cutting system imbal-
ance
Too few or too many blades. Do a check of the blades on the blade disc.
Outside working area
The boundary wire connections to the charg-
ing station are crossed.
Check that the boundary wire is connected
correctly.
The boundary wire is too close to the edge of
the work area.
Check that the boundary wire has been laid
according to the instructions. Refer to
To in-
stall the boundary wire on page 18
.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
Try moving the boundary wire.
The product finds it hard to distinguish the
signal from another product installation close
by.
Put the product in the charging station and
generate a new loop signal.
Slope too steep
The product stopped because the slope is
too steep.
Change the installation of the boundary wire
to not include this steep part of the work
area. Refer to
To put the boundary wire in
a slope on page 15
.
Empty battery
The product cannot find the charging station. Change the position of the guide wire. Refer
to
To install the guide wire on page 18
.
The battery is at the end of its life cycle. Replace the battery. Refer to
Battery on
page 35
.
The charging station’s antenna is defective. Check if the indicator lamp in the charging
station flashes red. Refer to
Indicator lamp in
the charging station on page 42
.
The charging plates on the product or con-
tact plates on the charging station are corro-
ded.
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your authorized service technician.
1650 - 005 - 17.03.2022 Troubleshooting - 37
