5 Maintenance
5.1 Introduction - maintenance
WARNING: The product must be
switched off before any maintenance is
done.
WARNING: Wear protective gloves.
For better operation and longer service life, make sure
to clean the product regularly and replace worn parts.
All maintenance and servicing must be done according
to Husqvarna's instructions. Refer to
Warranty on page
51
.
When the product is first used, the blade disc and
blades should be inspected once a week. If the amount
of wear during this period has been low, the inspection
interval can be increased.
It is important that the blade disc rotates easily. The
edges of the blades should not be damaged. The
lifetime of the blades varies immensely and depends for
instance on:
• Operating time and size of the work area.
• Type of grass and seasonal growth.
• Soil, sand and use of fertilizers.
• The presence of objects such as cones, windfalls,
toys, tools, stones, roots and the like.
The normal life is 3 to 6 weeks when used under
favorable conditions. Refer to
Replacement of the
blades on page 34
on how to replace the blades.
Note: Working with blunt blades gives a poorer
mowing result. The grass is not cut cleanly and more
energy is needed resulting in the product not mowing
such a large area.
5.2 Clean the product
CAUTION: Never use a high-pressure
washer to clean the product. Never use
solvents for cleaning.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Use a soft brush
to clean the product. The product can be cleaned with
running water from a water hose.
Husqvarna recommends to use a special cleaning and
maintenance kit, available as accessory. Speak to your
Husqvarna representative for more information.
5.2.1 To clean the chassis and blade disc
Examine the blade disc and blades weekly. To clean the
product fully, the body of the product can be removed. If
the product is dirty, use a brush or a water hose to clean
the product. Do not use a high-pressure washer to clean
the product.
1. Push the ON/OFF button to switch off the product.
The product is disabled when the indicator lamp is
not lit.
2. Carefully pull the top cover at the rear, the front
and the middle.
3. Lift up the top cover to remove it.
4. Find the 4 positions where the body is attached.
5. Push the maintenance tool down in 1 of the 4
positions, and pull the body up.
6. Continue with the remaining positions while you
hold the body up.
1650 - 005 - 17.03.2022 Maintenance - 33
