4. Push the PARK button.
5. Select an operating mode. Refer to
Operating
modes - Park on page 32
.
6. Push the OK button.
7. Close the hatch.
4.3.1 Operating modes - Park
•
Park until further notice
•
Start with schedule
4.3.1.1 Park until further notice
Use the operating mode
Park until further notice
for the
product to go back to the charging station. The product
will stay in the charging station until you select a new
operating mode.
4.3.1.2 Start again with next schedule
Use the operating mode
Start again with next schedule
for the product to go back to the charging station. The
product will stay in the charging station until the next
Schedule
setting.
4.4 To stop the product
1. Push the STOP button to make the product and
the cutting motor stop.
4.5 To set the product to OFF
1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds.
3. Make sure that the LED indicator on the keypad is
off to make sure that the product is set to OFF.
4.6 To charge the battery
WARNING: Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a long
period, the battery can be empty and must be charged
before you can start the product. In the
Main area
mode,
the product cuts and charges automatically.
1. Push the ON/OFF for 3 seconds button to start the
product.
2. Put the product in as far as possible in the
charging station.
3. Make sure that the charging plates on the charging
station connects to the contact plates on the
product.
4. Do a check that the display shows the message
CHARGING
to make sure that the product is
connected correctly to the charging station.
4.7 Adjust the cutting height
CAUTION: During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
4.7.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch.
3. Turn the cutting height adjustment knob to select a
cutting height.
a) Turn clockwise to increase the cutting height.
b) Turn counterclockwise to decrease the
cutting height.
32 - Operation 1462 - 007 - 14.03.2022
