7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
7.2 Storage
• Fully charge the product. Refer to
To charge
the battery on page 35
.
• Disconnect the product with the main switch.
Refer to
To switch off the product on page
34
.
• Clean the product. Refer to
Clean the
product on page 36
.
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level
ground during storage, or use a Husqvarna
wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a container with grease.
Note:
If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
7.3 Disposal
• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the
battery, refer to
To remove the battery on
page 54
.
7.3.1 To remove the battery
CAUTION:
Only remove the battery
when you dispose the product. When
you remove the warranty seal, the
Husqvarna warranty is no longer
applicable.
1. Disconnect the product with the Main switch.
Refer to
To switch off the product on page
34
.
2. Pull out the grommet on the charging cable
at the very front of the product, and carefully
remove the connector.
3. Lift the cover, one corner at a time.
4. Remove the 14 screws with a Torx 20.
5. Lift the rear edge of the top section of the
chassis.
6. Disconnect the MMI cable from the main
circuit board.
7. Remove the top section of the chassis.
8. Remove the 3 screws that holds the battery
with a Torx 20.
9. Disconnect the battery connection from the
main circuit board.
10. Open the battery cover and remove the
battery.
54
- Transportation, storage and disposal
1439 - 002 -
