The schedule function controls which hours the
product should operate and not operate. When
the product is not operating it is parked in the
charging station. The operating hours and days
can be seen in an overview in the Automower
®
Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the
work area is less than the maximum capacity the
schedule should be used to minimize wear on the
grass and to the product.
To calculate the schedule setting, refer to
To
calculate the schedule setting on page 26
.
3.11.1.1 To edit the schedule settings
1. Select
Settings > Schedule > Edit
in the app.
2. Select the pencil symbol in the app.
3. Select which days of the week and hours the
product must operate.
4. Select
Save
.
3.11.1.2 To add a new schedule setting
1. Select
Settings > Schedule > Edit
in the app.
2. Select the plus sign in the app.
3. Select which days of the week and hours the
product must operate.
4. Select
Save
.
3.11.1.3 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2
/
ft
2
.
2. Divide the m
2
/ ft
2
of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note:
The operation capacity is approximate and
is calculated for flat and open work area. If the
work area has a lot of slopes or obstacles, you
need to increase the
Schedule
settings.
Model Approximate operation ca-
pacity, m
2
/h / ft
2
/h
Automower
®
520 92 / 990
Automower
®
550 208 / 2240
Example: A lawn of 500 m
2
/ 5400 ft
2
, cut with an
Automower
®
520.
500 m
2
/ 92 ≈ 5.5 h.
5400 ft
2
/ 990 ≈ 5.5 h.
Days /
week
h / day Schedule settings
7 5.5 07:00 - 12:30 / 07:00
am - 12:30 pm
3.11.2 Operation
In the Operation's menu it is possible
to change the settings of the
Weather
timer, ECO mode
and
Spiral cutting
.
3.11.2.1 Spiral cutting
If the product enters an area where it senses the
grass is longer than average, it can change the
movement pattern to
Spiral cutting
. This means
that the product mows in a spiral pattern to faster
cut the area with longer grass. It is possible to set
the intensity of the
Spiral cutting
.
Very low / Low
intensity means that
Spiral cutting
begins less
often.
High / Very high
intensity means that
Spiral
cutting
begins more often.
Note:
Spiral cutting
is only started in the
Main
area
mode. Cutting in the
Secondary area
mode
does not let the product to start
Spiral cutting
.
Spiral Cutting
does not start in slopes steeper
than 15%.
26 - Installation
1439 - 002 -
