62
Noise Filter
(Advanced)
Noise Filter adjusts the sonar Noise Filter to limit interference on the display from sources such as
your boat engine, turbulence, or other sonar devices. The Noise Filter menu choice is available
when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
NOTE: The Off setting removes all filtering; Low, Medium and High settings add progressive
filtering of the sonar returns. In some deep water situations, the High setting may actually hinder
your unit’s ability to find the bottom.
To c
hange the Noise Filter setting:
1. Make sure you are in Advanced User Mode, then highlight Noise Filter on the Sonar main
menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Noise Filter setting.
(Off, Low, Medium, High1, High2, High3, Default = Low)
Max Depth
(Advanced)
Max Depth adjusts the maximum depth of operation. The performance of your 700 Series™
Fishing System can be tuned to the maximum depth you will be fishing in by setting the Max
Depth. When a maximum depth is set, your 700 Series™ Fishing System will not attempt to
acquire sonar data below that depth, thus increasing overall performance. When Max Depth
is set to Auto, the 700 Series™ Fishing System will acquire bottom readings as needed (within
the capacity of the unit). If the bottom is deeper than the Max Depth setting, the digital depth
readout will flash, indicating that the 700 Series™ Fishing System cannot locate the bottom.
The Max Depth menu choice is available when User Mode is set to Advanced (see Setup Menu
Tab: User Mode).
T
o change the Max Depth setting:
1. Make sure you are in Advanced User Mode, then highlight Max Depth on the Sonar main
menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Max Depth setting.
(AUTO, 10 to 1500 feet, 3 to 500 meters [International Models only], Default = AUTO)
61
Surface Clutter
(Advanced)
Surface Clutter adjusts the filter that removes surface clutter noise caused by algae and aeration.
The lower the setting, the less surface clutter will be displayed. The Surface Clutter menu choice is
available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
T
o change the Surface Clutter setting:
1. Make sure you are in Advanced User Mode, then highlight Surface Clutter on the Sonar main
menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Surface Clutter setting.
(Low = 1 to High = 10, Default = 5)
Surface
Clutter
