Programming the timer (DWF 35/34)
You can delay that start of a programme in
increments of one hour for up to 9 hours.
- Switch mains switch 1 to ON.
- Immediately press the TIMER button 8
The numerical display 7 changes to
1 .
- Press the TIMER button as many times
as necessary until the numerical display
shows the required delay.
- To erase the time delay setting,keep
pressing the TIMER button until 0
appears in the numerical display.
You can change your programme
selection as often as you like during
the intervening period before the
dishwasher starts up.
Time-remaining indicator (DWF35/34)
The time-remaining indicator is self-learning.
When the programme begins,it displays the
estimated duration of that programme.This
figure is based upon the duration of the
previous programme,or if the dishwasher is
being used for the first time,the programme
used for testing the dishwasher in the factory.
While the programme is running,the indicator
shows the amount of time before the
programme ends. The time remaining is also
adjusted to account for the temperature of
the water supply and the number of dishes.
Intensive drying function (DWF35/34)
Activating the intensive drying function
increases the temperature during the
rinse-aid stage which gives better drying
results.
- Press and hold the ‘Normal wash’
button and set the mains switch 1 to
ON.
- Release both buttons.
Either 1 (ON) or 0 (OFF) flashes in the
numerical display 7 .
- Press the normal wash button to
change the setting.
- Set the mains switch 1 to OFF.
The new setting is stored in the
dishwasher memory.
Altering the programme.
It is possible to change the programme within
2 minutes of switching the dishwasher
ON.
Should it be necessary to change the
programme after this period,the selected
programme cycle that has already begun will
be completed first of all.
(DWF35 and DWF34)
The new remaining time displayed is the sum
of the remaining time from the preceding
programme cycle and the remaining time
attributable to the new programme that has
been selected.
Cancel Programme (Reset)
Only when the mains switch is ON.
Press the programme end buttons 11
together and hold them for approx 3 seconds.
Then:
(DWF35 and DWF34)
- The numerical display shows 0.
- The programme continues for approx
1 minute.
- When it has ended,set the mains
switch 1 to OFF.
- Close the detergent compartment.
To restart the dishwasher, set the
mains switch 1 to ON again and select
the desired programme.
(DWF33 and DWF30)
- The programme continues for approx 1
minute.
The programme End indicator light 10
and the indicator light for the
programme which was running will
both light up.
- Set the mains switch 1 to OFF.
- Close the detergent compartment.
To restart the dishwasher, set the
mains switch 1 to ON again and select
the desired programme.
Washing Dishes
20
