75573
6
Verklein
Vergroot
Pagina terug
1/84
Pagina verder
6
GB
Start and Programmes
The time to end is displayed in hours and minutes and
counts down each minute, this includes the cool
tumble phase, the heat setting HIGH or LOW
is also shown.
When timed programmes are selected the time
displayed throughout the cycle is the actual time
remaining.
When an Automatic programme is selected, the time
displayed is an estimate of the time remaining. When
the programme is selected the display shows the time
required to dry a full load, after around 10 minutes the
controller calculates a better estimate of the cycle time.
The colons between the hours and minutes in the
display flash to show that the time is counting down.
When the programme finishes its cool tumble phase
the display will show .
The display also shows if there is a problem with your
dryer, if this occurs the display will show F followed by
a fault code number (see Troubleshooting).
Empty Water Icon / Container
(If you have plumbed your dryer to a drain this icon can
be ignored, as there is no need to empty the water
container).
When this icon is on (not flashing) it reminds you to
empty the water container.
If the water container fills during a programme, the
heater turns off and the dryer does a period of Cool
Tumble then the icon flashes and the buzzer sounds.
After this it stops and all progress icons come on and
the empty water icon flashes.
You must empty the water container and restart the
dryer or the clothes will not dry. After re-starting the
dryer the icon will take a few seconds to go out.
To avoid this always empty the water container each
time you use the dryer (see Maintenance).
Door Opening
Opening the door during a programme will stop the
dryer and have the following effects:
All 4 progress icons come on.
During a delay phase the delay will continue to
count down. The start button must be pressed to
resume the delay programme.
The progress icons will change to show current
status.
During the drying part of the programme, the
colons on the display stop flashing to show that
the time has stopped counting down.
The start button must be pressed to resume the
programme. The progress icons will change to
show the current status, the colons flash and count
down continues.
During an Airing or Cool Tumble programme, or
Post Care phase, the programme ends and the
display shows .
Note
If you have a power cut, switch off the power or
remove the plug, press the START button and the
programme will resume.
! Warning, after pressing the start button, the
programme cannot be changed.
! ON/OFF button : press this button and you pause
the programme. Press it again and the programme will
resume, if you have opened the door you will need to
press the Start button first to resume the programme.
! START/CANCEL button : press and hold in this
button and you cancel a programme, the display then
shows .
Option buttons / icons
These buttons are used to customise the selected
programme to your requirements. A programme must
have been selected, by pressing a programme selection
button, before an option can be selected. Not all
options are available for all programmes (see Start
and Programmes). If an option is not available and
you press the button, the buzzer will beep four times.
If the option is available there will be one beep and
the option icon lights to confirm the selection.
Time Delay
The start of some programmes (see Start and
Programmes) can be delayed for up to 18 hours.
Ensure the water container is emptied before setting a
delayed start.
To set, press the Time Delay button, the display shows
and the option TIME DELAY icon comes on.
Press again and a 1 hour delay is selected and the
display shows , each further press of the button
adds 1hr to the delay. When is displayed a
further press the display shows and after a
couple of seconds cancels the delay.
Pre Care
This option is only available if a delayed start has
been selected. It tumbles the clothes occasionally
during the delayed period to help prevent creases
developing.
Alarm
Available on all programmes and allows the buzzer to
give a signal at the end of the drying cycle, to remind
you that the clothes are ready to be removed.
Press the button and the icon will show that the option
is selected.
Post Care
When available and selected, the clothes are
occasionally tumbled after the end of the drying and
cool tumble cycles, to help prevent creases
developing should you not be available to remove the
load immediately the programme is complete.
TIME DISPLAY
The display shows either the amount of time delay
remaining or an indication of the amount of time left for
a drying programme.
The delay time is displayed in hours and
counts down each hour. The TIME DELAY icon
flashes after the start button has been pressed.
The Controls
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hotpoint-Ariston ASD 70 C bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hotpoint-Ariston ASD 70 C in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 1,73 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info