68 04.2007 TR10A041-C RE
7.7 MENU 7 – behaviour during operation in the
CLOSE direction (see fig. 28 )
In this menu, the automatic belt relief, the braking
behaviour and the speed in the CLOSE end-of-travel
position can be influenced.
Note
After the menu changes, a learning cycle may have to be
carried out.
Display Function
Soft stop
long
short
Relief
automatic
long
Speed
slow
normal
Press the PRG button to return to normal operation
(menu 0).
7.8 MENU 8 – force limit during operation in the
OPEN direction (see fig. 29 )
In this menu, the sensitivity of the automatic force limit
for the opening cycle can be set (factory setting: para-
meter 4).
Note
Increasing the force value (parameter greater than 4) is only
possible if parameter 3 has been selected in menu J.
ATTENTION
Do not select an excessively high setting as
excessive force may cause damage to equip-
ment or injuries to persons.
For doors moving easily, a low value can be selected
when the sensitivity to obstructions is to be increased.
Press the PRG button to return to normal operation
(menu 0).
7.8.1 Checking the forces in the OPEN direction
When changing the settings in menu 8, the forces as
defined in EN 12453 in the OPEN direction must be
complied with, i.e. a subsequent check is absolutely
essential.
7.9 MENU 9 – behaviour during operation in the
OPEN direction (see fig. 30 )
In this menu, the automatic belt relief and the braking
behaviour in the OPEN end-of-travel position can be
influenced.
Note
After the menu changes, a learning cycle may have to be
carried out.
Display Function
Soft stop
extra long
long
short
Relief
automatic
short
Soft start from CLOSE end-of-travel position
short
long
Speed
slow
normal
fast
Force limit response
stop
short reverse
Note
- Parameters 0 and 6: these parameters are matched to
the characteristics of retractable up-and-over doors.
- Parameters A and b: these parameters only need to be
set when parameter 3 has been selected in menu J.
Otherwise, parameter A is active in this menu.
- Parameter b: if error 5 (force limit) occurs when the door
is opening, the door travels a short distance back (roughly
10 cm of carriage) in the opposite direction and then
stops.
Press the PRG button to return to normal operation
(menu 0).
ENGLISH
