31
TENSIONING THE BELT
If you can feel a slipping sensation when running on the treadmill, the running belt must
be tightened. In most cases, the belt has stretched from use, causing the belt to slip. This
is a normal and common adjust-
ment. To eliminate this slipping,
tension both the rear roller bolts
with the appropriate size allen
wrench, turning it 1/4 TURN to
the right as shown. Try the tread-
mill again to check for slipping.
Repeat if necessary, but NEVER
TURN the roller bolts more than
1/4 turn at a time. the belt ten-
sion is set properly when the run-
ning belt is 1/4 of an inch from
the deck.
CENTERING THE BELT
If the running belt is too far to the right side, use the supplied Allen wrench to turn the
right tension bolt clockwise 1/4 turn at a time until the belt remains centered during use.
If the running belt is too far to the left side, turn the left tension bolt clockwise 1/4 turn at
a time until the belt remains centered during use.
IF THE BELT IS TOO FAR TO
THE LEFT SIDE:
• Turn the left roller bolt 1/4 turn
clockwise (tighten).
IF THE BELT IS TOO FAR TO
THE RIGHT SIDE:
• Turn the right roller bolt 1/4
turn clockwise (tighten).
TREADMILL SERIES
32
MAINTENANCE PROCEDURES
Cleanliness of your Horizon Fitness treadmill and its operating environment will keep main-
tenance problems and service calls to a minimum. For this reason, Horizon Fitness recom-
mends that the following preventive maintenance schedule be followed.
AFTER EACH USE (DAILY)
Turn off the treadmill with the on/off switch, and unplug the power cord from the wall out-
let.
WARNING!
To remove power from the treadmill, the power cord must be disconnected from the wall
outlet.
• Wipe down the running belt, deck, motor cover, and console casing with a damp cloth.
Never use solvents, as they can cause damage to the treadmill.
• Inspect the power cord. If the power cord is damaged, contact Horizon Fitness.
•Make sure the power cord is not underneath the treadmill or in any other area where it
can become pinched or cut.
• Check the tension and alignment of the running belt. Make sure that the treadmill belt
will not damage any other components on the treadmill by being misaligned.
EVERY WEEK
Clean underneath the treadmill, following these steps:
•Turn off the treadmill with the on/off switch, then unplug the power cord at the wall out
let.
•Fold the treadmill into the upright position, making sure that the lock latch is secure.
• Move the treadmill to a remote location.
•Wipe or vacuum any dust particles or other objects that may have accumulated unde
neath the treadmill.
• Return the treadmill to its previous position.
EVERY MONTH
• Inspect all assembly bolts of the machine for proper tightness.
EVERY YEAR
• It may be necessary to rewax your treadmill running deck and belt once a year to main
tain optimal performance of your treadmill. Please contact your local dealer with ques
tions about applying wax to your treadmill.
Warning! Only use paraffin wax provided by Horizon Fitness!
• Lubricate the air shocks with teflon based spray.
TREADMILL SERIES
