UNPACKING
Take caution when handling and transporting this unit. Never
open box when it is on its side. Once the banding straps have
been removed, do not lift or transport this unit unless it is fully
assembled and in the upright folded position, with the lock
latch secure. Unpack the unit where it will be used. The
enclosed treadmill is equipped with high-pressure shocks and
may spring open if mishandled. See owner’s guide for refer-
ence. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN INJURY! Place your treadmill on a level flat sur-
face. It is recommended that you place a protective covering
on your floor.
NOTE: It is recommended that you apply grease
to the threads of each bolt as you assemble your
treadmill, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
= Tighten
A) 20mm Bolt
Quantity: 10
Parts
• 1 Power Cord
• 1 Safety Key
• 1 Console Skirt
• 1 Hardware Pack (contents listed below)
• Left and right outer console mast boots
• Left and right Handle Bar (4.1T & 5.1
T HRC)
• Console Assembly
• Left and Right Console Mast
Tools (included)
• 5mm Allen Wrench/Phillips Screw Driver
• 8mm Allen Wrench
or
• 6mm Allen Wrench
HARDWARE
1 2
ASSEMBLY
GUIDE
C) Screw
Quantity: 4
B) 50mm Bolt
Quantity: 2