7
Note: we recommend you keep the transit bracket and
screws to protect the machine for future transit.
The Manufacturers will not be responsible for any
damage to the machine caused by not following the
instructions relating to releasing the transit protection.
The user is responsible for all installation costs.
Connecting the fill hose
This machine has an inlet hose with 19 mm (3/4”) threaded ferrules fitted to the
ends to attach between the threaded connector on the appliance and the water
supply.
Only use the new hose supplied to connect the machine and ensure that the
sealing washers are in place inside the hose connectors.
Do not re-use old hoses which are attached to existing installations.
Do not over-tighten the connections. Hand tight is sufficient.
Do not trap or kink the hoses.
Connect the straight end of the hose to the stop taps.
Acqua-stop (fitted to certain models)
The fill hose supplied with this machine has a double skin
and incorporates a water valve (A). If the inner hose
bursts the valve will automatically shut off the water
supply to prevent flooding. The indicator turns red (B).
Should this happen, turn off the water supply immediately
and have a new fill hose fitted by Hoover Service.
If the inlet hose’s connection point is changed, check that
the 3/4” threaded ferrule on the inlet hose is firmly
attached to the electrovalve connector.
WARNING: DO NOT LEAVE THE PACKAGING IN THE
REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE
OF DANGER.
