GB
In any case, do not use any descaling products to clean or rinse the boiler.
Switch o the appliance and unplug it.
Put the iron on the heat-resistant iron resting mat (3). Wait at least 30 minutes allowing
the soleplate and the generator to cool down.
Lock the iron with the iron lock system (2). Please report to the dedicated chapter 1.2
for further instructions.
Store both steam and electrical cables in the cord storage feature (6).
Troubleshooting
Problem Cause Solution
The appliance does not
become hot
There is a connection
problem
Check the mains cord, the
plug and the wall socket
The appliance is not
switched on
Press on the on/o switch
The soleplate temperature
is too low
Set a higher temperature
of the soleplate
The appliance does not
produce steam
The appliance is not
switched on
Press on the on/o switch
The boiler has not yet
heated up
Wait a few moments until
the steam ready LED is o
The water tank may be
empty
Rell the water tank
You are not pressing the
steam trigger
Press the steam trigger
The soleplate temperature
is set to the maximum
It works but steam is not
visible as very hot and dry.
Steam escapes from the
calc removal cap when
ironing
The calc removal valve is
not tightened enough
Switch o the appliance
and let it cool down.
Remove the calc removal
cap and tighten the valve
correctly
The anti-scale valve is
damaged
Contact your after sales
service
The empty water tank
LED is on
There is no more water in
the tank
Rell the water tank with
water
The soleplates becomes
dirty or brown
There should be chemical or
additives in the water used
for ironing
Never use any chemical or
additives in the water.
Contact your after sales
service if the linen is still
dirty
The linen is still dirty Clean the soleplate with a
non-metallic sponge
Water stripes appear on
the textile
Your ironing board cover is
saturated in water
Change the cover or use a
mesh ironing board
Some scale deposit
appears on the soleplate
Your boiler has not been
rinsed for a while
Follow the indications in
the appropriate chapter
