11 69-0628B—1
Programming
You can program your thermostat to
automatically lower and raise the temperature
one or more times every 24 hours, depending
on the number of program pins used.
Before setting your program
Lift thermostat flip-up cover and you will find
the 24-hour program dial. The slots on the
program dial (Fig. 4) are for the program pins
that can be inserted at ten minute intervals.
Three red and three blue program pins are
included with your thermostat. The red pins start
the high-temperature period; the blue pins start
the low-temperature period. A heating program
has been preprogrammed. A red pin is inserted
at 6:00 AM for high temperature (comfort period);
a blue pin is inserted at 10:00 PM for low
temperature (energy saving period). Two
additional sets of pins are located in the program
pin storage area. You can set up to six tem-
perature changes with the pins supplied. We
recommend at least five hours for each energy
saving period.
To change the pins or add a new energy
savings period—
• To insert a pin, push it straight into the selected
notch on the program dial until it is completely
seated.
• To remove a pin, press against the program dial
and pull the pin straight out. DO NOT attempt to
change a pin if it is engaged with the program
index wheel.
• On heating/cooling systems, you must reset the
pins when the seasons change. You will also
probably want to change the lever positions.
