PROGRAMMING YOUR ST9400S
The Built-in Programmes
The built-in programmes give you a starting point that you can personalise to your
own requirements. Your Installer should have selected one and ticked the box
alongside it. If there is no tick, the product normally leaves the factory with Profile A
installed, but it is a simple matter to select one of the other profiles (see Changing
the Installer Parameters, page 12).
Built-in Programme (Profile A)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
Heating
6:30am 8:30am 4:30pm 10:30pm Not used Not used
Hot Water
6:30am 8:30am 4:30pm 10:30pm Not used Not used
Your Personal Programme
The table below has been left blank for you to record your own personal programme.
For ease of use, your ST9400S is supplied as standard with only 2 on/off’s enabled. To
enable ON/OFF period 3 see Fine Tuning your ST9400S (page 12).
Built-in Programme (Profile b)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
Heating
6:30am 9:30am 4:30pm 11:00pm Not used Not used
Hot Water
6:30am 9:30am 4:30pm 11:00pm Not used Not used
Built-in Programme (Profile C)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
Heating
6:30am 7:30am 5:00pm 10:00pm Not used Not used
Hot Water
6:30am 7:30am 5:00pm 10:00pm Not used Not used
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
Heating
Hot Water