Note: When pressing the button the next ON or OFF marker may start to flash.
This indicates you have tried to set a time equal to one of the next programme times
already in the memory. Similarly, when pressing the button the previous ON or
OFF marker may start to flash. This indicates you have tried to set a time equal to
one of the previous programme times. If this happens the ST9400A simply moves
both times together as long as you continue to press the or buttons. Follow
the procedure in ‘Reviewing the Programme Times’ (page 7) to check and adjust
these times as necessary.
c.
‘SET OFF-TIME 1’ will be displayed and the first OFF 1 time will now be flashing. If
you do not wish to change the time, press the green button and move to the next
step. Otherwise, use the
or
buttons to change the time. Press the green
button to confirm the time is correct and move to the next step. ‘SAVED’ will be
displayed for a moment to confirm that any change has been saved to memory.
d. The remaining ON and OFF times (ON 2, OFF 2) can be set by using the
or buttons to change the time, and the green button to confirm the time
is correct and move to the next step. If you do not wish to change the time, just
press the green button to move directly to the next ON/OFF time without
making any changes.
e. After setting or reviewing the last off time, OFF 2, the message ‘COMPLETE’ will
be displayed to indicate the times have been set.
Exiting HOT WATER Programming Mode:
To exit HOT WATER programming mode, move the slider to the RUN position. This
can be done at any time during the programming process, and any changes made
and confirmed with the button will have been saved.
Note: If the unit is left in HOT WATER Programming mode for more than 10 minutes without
the slider being moved or any buttons pressed, the message ‘MOVE SLIDER’ will be
displayed. Press a button to finish programming, or move the slider to the RUN position.
PROGRAMMING YOUR ST9400A
