Handleiding Honeywell HFD-014 Series (pagina 3 van 15) (Engels, Frans, Spaans)

723803

Verklein

Vergroot

Pagina terug

1/15

Pagina verder

4 5

SET-UP (ALL MODELS)

• Select a firm, level and flat location. For best airflow, locate the unit at least 6 inches (15.2 cm) from

any wall or furniture.

• When operating, large volumes of air are drawn toward the air cleaner. Surrounding areas should be

cleaned and/or vacuumed frequently to prevent build-up of dust and other contaminants. This may also

help prolong the life of the filter. If the unit is placed on a light colored carpet, a small mat or rug should

be used underneath to prevent staining. This is especially important in homes with contamination from

smoking or fireplaces.

ENHANCED ODOR REDUCTION (HFD-014, HD010WHS, HD010LHS, HD010RHS ONLY)

The washable pre-filter came installed in your air purifier and removes larger particles from the air that

passes through the filter. You may use this washable pre-filter, or you have the choice to use the optional

Odor-Lock™ Pre-filter (in HFD-014, HD10WHS, HD010LHS, HD010RHS ONLY). In addition to capturing

larger particles, the Odor-Lock™ Pre-filter will also trap common household odors and gases. If you

choose to use the Odor-Lock™ Pre-filter, you must remove the installed washable pre-filter then insert the

Odor-Lock™ Pre-filter. (See “Installing The Odor-Lock

™

Pre-filters” on page 7).

NOTE: Please only use one pre-filter in your air cleaner at a time. You will need to choose whether you

want to use the permanent washable pre-filter or the replaceable Odor-Lock™ Pre-filter.

Both are included with your air cleaner at the time of purchase (in HFD-014, HD10WHS, HD010LHS,

HD010RHS ONLY).

OPERATION (HFD-015, HFD-110 and HD110)

• Press the Power ( ) button once. The unit will start at the

Medium Power level and remain on this setting until another

cleaning level is chosen (Fig. 6).

• Select a power level by pressing one of the three power level

buttons: High (

), Medium (

) or Low ( ) (Fig. 7). The indicator

light above the selected button will illuminate.

• Press the Power button again to turn off the air purifier.

Timer Operation

• Press the Timer (

) button if you would like your air cleaner to

run and then automatically shut-off after a certain amount of time

(choose from between 4, 8 or 12 hours). This is convenient if

you would like your air cleaner to run during the night but then

shut-off automatically in the morning (choose the 8 hour setting).

• The timer can be turned off by repeatedly pressing the Timer

(

) button until all of the timer indicator lights go out.

NOTE: Removing the ifD

Micro-filter assembly or turning the

unit off will cancel the Timer function.

OPERATION (HFD-010, HD010, HFD-013 and HFD-014 SERIES)

• Ensure the unit is in the OFF (O) position and is plugged into

a working electrical outlet.

• Rotate the control knob to the desired speed level: High (

) or

Low (

) (Fig. 5).

• The indicator light will illuminate when the power is on.

• Turn the control knob to the Off (O) position to turn off the

air purifier.

Fig. 5

Fig. 7

Fig. 6

Fig. 8

Check Filter Indicator - When it is time to check and clean the filters, an indicator light will illuminate

Fig. 9 (HFD-015, HFD-110 and HD110 Only). When this light comes on, you will need to clean the

primary ifD

filter and clean or replace the pre-filter. (See Filter Cleaning instructions on page 6). It is

recommended that you periodically check the filters.

To Reset Electronic Filter Check - After the ifD

filter and washable pre-filter have

been cleaned/replaced and re-installed in the unit, plug the unit into the power outlet

with the unit still in POWER OFF mode, press and hold the CHECK FILTERS RESET

button until the LED will no longer be illuminated.

The cleaning intervals are intended as guidelines only. Performance of any filter

media is dependent upon the concentration of contaminants going through the

system. High concentrations of contaminants such as dust, pet dander and smoke

particles will reduce the useful performance of the filter and they may need to be

cleaned more frequently.

FILTER CLEAN INDICATORS AND FILTER RESET (HFD-110, HFD-015 and HF110)

Fig. 9

Filter

Reset

Button

Indicator

Light

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Honeywell HFD-014 Series Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info