EN 31HOW TO USE THE MACHINE
5.4.12 CARD PROTECTION DEVICE
The electronic card has a self-resetting protector which breaks the circuit if there
is a fault in the electrical system. It results in the stopping of the engine and is
signalled by the pilot lamp turning off.
The circuit automatically resets after a few seconds but the cause of the fault
should be ascertained and dealt with to avoid re-activating the protection device.
To avoid activating the protection device.
– do not reverse the leads on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful to not cause short-circuits.
5.4.13 S
UMMARY OF THE MAIN ACTIONS TO BE CARRIED OUT WHEN USING THE MACHINE
IMPORTANT
To ...
Start the engine (☛ 5.4.1)
Go forward (☛ 5.4.2)
Brake or stop (☛ 5.4.3)
Reverse (☛ 5.4.4)
Cut the grass (☛ 5.4.5)
You must ...
Ensure that all the conditions allowing starting are met,
and then turn the key
Move the accelerator;
for mechanical drive models: push the pedal right
down, engage the gear (☛ 4.22) and then gradually
release the pedal;
for hydrostatic drive models: press the drive pedal
forward; (☛ 4.32);
Reduce the engine speed and press the brake pedal
Stop the machine;
for mechanical drive models: put into neutral, push the
pedal right down, engage reverse, (☛ 4.22) and then
gradually release the pedal;
for hydrostatic drive models: press the drive pedal
back (☛ 4.32).
Fit the grass-catcher or stone-guard and move the acce-
lerator;
engage the blades and adjust the cutting height.
for mechanical drive models: push the pedal right
down, engage the gear (☛ 4.22) and then gradually
release the pedal;
for hydrostatic drive models: press the drive pedal
forward; (☛ 4.32);
➤
➤
➤
➤
➤
➤
