3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protru-
ding shaft (2) with the spokes directed
towards the seat.
Line up the hole in the steering wheel hub
with the hole in the shaft and insert the
pin supplied (3) using a hammer, ensuring
that the end comes completely through to
the opposite side.
To avoid damaging the steering wheel, use a punch of the
same size as the pin when hammering it in the last part
3.3 FITTING THE SEAT
The seat (1) is supplied attached to a
support bracket (2) on which has been fit-
ted a micro-switch (3).
Fit the support bracket (4) using the screw
pins (5) supplied, fully tightening the rela-
tive nuts (6).
Connect the micro-switch socket (7) to the one coming
from the general wiring (8) to ensure that the safety device works, and
then fit the wire into the wire-holder (9).
!
ATTENTION!
NOTE
EN 10 UNPACKING AND ASSEMBLY
