INSTALLATION
Place the rear of the unit at least 30 cm from the wall and ensure that there is at least 1.50 metres free
space at the front.
Screw the connector firmly to the hose and then connect it to the unit and the other end to the flat nozzle.
Connect the exhaust hose to the flat nozzle and place it as flexibly as possible in the window.
Ensure that no objects or plants are placed in front of the flat nozzle.
When you are certain that the above-mentioned rules have been followed and that no further dangerous
situations could arise, push the plug into the socket!
The unit is now ready for use
NORMAL USE
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the FANSPEED button to set the speed to High, Medium or Low
Please note: If the room is very hot and you have selected the COOLING function, you must select the lowest
speed. The air that is drawn into the unit will then have more time to cool, and the air in the room will be
cooled more quickly.
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located. After 15 seconds the actual ambient temperature, which is to be cooled, is re-displayed.
Please note: there is no guarantee that this temperature will actually be reached.
Please note: This unit has a built-in self-protection system. If the equipment is switched off, you should wait
for three minutes before restarting it. In this way, the refrigerant will be able to re-stabilise.
USE OF TIMER
Timer for switching on the unit
The air conditioner has a function that allows the unit to be switched on at a set time.
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the speed button to set the speed to High, Medium or Low
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located.
Now press the POWER button to switch the unit off
Press TIMER and using the ADJUST/ARROWS keys select the number of hours after which the unit is to be
switched on.
Timer for switching off the unit
The unit has a function that allows the unit to be switched off at a set time.
Press the POWER button to switch on the unit
Use the MODE button to select cooling, dehumidify or ventilator
Use the speed button to set the speed to High, Medium or Low
Use the ADJUST/ARROWS keys to select the correct temperature for the area in which the air conditioner is
located.
Press TIMER to switch on the timer and press ADJUST/ARROWS to set the number of hours until the unit is
to be switched off.
DRAINING OF WATER
In principle, all the water should be drained away via the air outlet by the ingenious evaporation system. If
the unit is operating in a very damp room, however, the reservoir will fill up more quickly than the water is
able to evaporate. In this case the unit will switch off so that the reservoir does not overflow. You can then
empty the unit via the drainage pipe at the rear. Don’t forget to re-tighten the drain plug when you have
finished.
GB
