14
CONNECTION
Terminal Positions
Rear
①
Power Cord Socket
②
AV1
③
AV2
④
AV3
⑤
COMPONENT IN, AUDIO terminals
⑥
VAR (Variable) AUDIO OUT terminal
⑦
HDMI1, 2 and mini stereo for Audio
⑧
PC Connection terminals
(D-sub 15 pin and mini stereo for
Audio)
⑨
(ANT) Aerial Socket
Side
⑩
AV4
⑪
Headphone Socket
Connecting Procedure
This unit is ready for various kinds of connections. Make a connection in the following steps. Be sure to turn off the
Main Power first when connecting external equipments.
1. Connect Power Cord to the rear panel.
2. Connect Aerial Lead.
3. Connect your external equipments to the unit if any.
4. Connect the Power Plug to the Wall Socket.
1. Connecting Power Cord to the Rear Panel
Connect Power Cord to the unit.
*Make sure not to connect the Power Plug to the Wall Socket
until all connections are completed.
2. Connecting Aerial Lead.
There are two ways to connect Aerial Lead.
When you do not have any other external equipment:
Connect the Aerial Lead directly into the Socket at rear panel.
When you have one or more external devices to connect:
1. Use RF cable to connect between each equipment and
Aerial.
2. Connect the Aerial Lead to an equipment “In” Socket
marked.
3. Connect the RF cable from the equipment “Out” to the other
equipment “In.”
4. Then, connect from the equipment “Out” to “ANT” on this unit
Socket on marked.
[Example: Connecting Aerial
through STB and VCR]
Precautions when connecting the aerial
Please use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel flat feeder
wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.
Avoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.
If noise appears in the picture of VHF-Low band channel, please use a double-shielded cable (not provided) for
RF LEADS to reduce the noise.
•
•
•
