169035
15
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
15
Functions & Controls
TXi 3000
HIGH-/LOW PASS
High Pass
This controller adjust the frequency of the loudspeakers onward (X-OVER switch position HP). The cut-off frequency is continuously adjustable
from 10Hz to 1200Hz. This controller adjust also the Subsonic-Frequency in the LOW PASS-Mode (X-OVER switch position HP).
Low Pass
This controller adjust the frequency of the loudspeakers upward (X-OVER switch position LP/BP). The cut-off frequency is continuously
adjustable from 30Hz to 150Hz. Together with the HIGH PASS-Filter, this controller is also working as Bandpass-Filter (BPF). The cutting-off
of the lower frequencies ensures a tight kickbass-signal. If this function is not desired, bring the HIGH PASS-Controller to the 10 Hz position.
Bass Boost
Variable Bass Boost from 0 up to +12dB at 45 Hz.
Input - RCA Inputs
Full range line input to connect with
the head unit RCA Outputs.
Line Out - RCA Outputs
RCA Outputs to send the line signal
to additional amplifiers.
Level Input
Adjust the input sensitivity
from 6 Volts to 0,2 Volts.
Remote
Terminal for the provided cable remote
controller, which allows to control the bass
level e.g. out of the driver's seat.
Power - LED (also located
on the remote controller)
If green LED lights up, the
amplifier is turned on.
Protect - LED (also located on the remote controller)
If the red LED lights up, the following matters occurs:
a) Overheating
b) Speaker wires shorted
c) Overload (Impedance, weak power supply)
d) Amplifier is damaged
The built-in electronic diagnostic protection saves the
amplifier and speakers from serious damages.
If the red LED lights up due to overheating, let the
amplifier cool down a while, then turn it on again. If the red
LED still lights up, observe therefor the section “TROUBLE
SHOOTING”
X-Over
The switch determinates the operation mode of the amplifier.
Position LP/BP:
The Lowpass-/Bandpass-Mode is suited for subwoofer operations. The
signal will be limited upward and only the bass frequencies will be
amplified. The cut-off frequency is adjustable by the LOW PASS-
controller.
Position HP:
The Highpass-Mode is suited for loudspeaker operations. The signal is
limited downwards and only the mids and highs will be amplified.
The cut-off frequency is adjustable by the HIGH PASS-controller.
Position FULL:
The Fullrange-Mode is suited for very huge loudspeaker systems or huge
backshelf systems. Thereby the whole freqencies will be amplified.
6
15

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hifonics txi3000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hifonics txi3000 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 1,38 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info