700135
22
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
22
INTERCONNECTION EXAMPLE
2-channel-mode: 1 x Stereo-System
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION
Connect the RCA lineouts of the head unit with the RCA jacks LINE IN of the amplier with appropriate high-value RCA cables.
Connect the front and rear speakers with the speaker outputs (SPEAKER OUTPUT + L - and + R -).
Always ensure that the total impedance load on the speaker outputs is not lower than 2 ohms.
Too low impedance cause high temperature and will shut down the amplier operation.
Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS
When using bigger speakers (more than 20cm) set the X-OVER switch to the FULL position (Full Range Signal).
When using smaller speakers (8.7cm - 16cm) set the X-OVER switch to the HP position (Highpass Mode) to avoid
any damage by lower frequencies on the speakers. The cut-off frequency is adjustable with the HP/BP controller and should
be set between 60Hz to 150Hz, depending on the size of the speakers.
The LP Controller is not in use in this interconnecting example.
LEVEL CONTROLLER
Turn the LEVEL controller of the amplier to the MIN position.
Turn the volume controller of the head unit to 80 - 90% of its full setting.
Turn the LEVEL controller clockwise until you hear some distortion.
Then turn back the LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER
The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
BASS REMOTE
The enclosed Bass Level Controller is not in use in this interconnecting example.
Do not connect loudspeaker cables with the vehicle’s chassis. Always ensure the correct polarity of all connections. The interchange
of plus and minus cause total loss of bass playback and could damage the speakers.
NOTE
Connect stereo RCA output (L/R) of the
head unit with LINE IN of the amplier
HP oder FULL
Loudspeaker left
2 – 8 Ohms
Loudspeaker right
2 – 8 Ohms
50A
POWER INPUT
FUSE
SPEAKER OUTPUT
BRIDGED
PROTECT
POWER
FULLHPLP/BP
LP HP/BP LEVEL
BASS LEVEL
CONTROLLER
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
0dB 18dB
LINE IN LINE OUT
RL
LEVEL
INPUT
X-OVER
MODE
10Hz 1.2kHz30Hz 250Hz MIN MAX
OFF
ON
LOW
HI
BASS BOOST
ZRX4002
GND +12VREM
ZRX4002
L
R
L
R
BLUE / WHITE
LOG0
POWER INPUT
FUSE
SPEAKER OUTPUT
BRIDGED
PROTECT
POWER
FULLHPLP/BP
LP HP/BP LEVEL
BASS LEVEL
CONTROLLER
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
0dB 18dB
LINE IN LINE OUT
RL
LEVEL
INPUT
X-OVER
MODE
10Hz 1.2kHz30Hz 250Hz MIN MAX
OFF
ON
LOW
HI
BASS BOOST
ZRX4002
GND +12VREM
ZRX4002
L
R
L
R
BLUE / WHITE
LOG0
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hifonics ZRX9002 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hifonics ZRX9002 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 6,24 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info