700148
24
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
24
OPERATING INSTRUCTIONS
INTERCONNECTION
Connect the RCA SUB OUT of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
Connect the subwoofer with the speaker outputs (SPEAKER OUTPUT + / -) by using appropriate wires.
Please ensure, that the total impedance load of subwoofer is not lower than 1 ohm. Too low impedance cause high
temperature and will shut down the amplifier operation.
Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
OPERATION MODE SWITCH
• The OPERATION MODE switch must be in position MASTER.
X-OVER MODE SWITCH
• The X-OVER MODE switch must be in position FULL.
LEVEL CONTROLLER
• Turn the LEVEL controller of the amplifier to the 9V position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the LEVEL controller clockwise until you hear some distortion.
• Then turn back the LEVEL controller slightly until you hear a cleaner sound.
EXTENDED BASS CONTROL
• The SUB BOOST controller adjusts the bass enhancement between 0db and +18dB.
• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.
Use this controller carefully!
• Please note the further information (EXTENDED BASS CONTROL) on page 19 (Section #3).
LOW PASS CONTROLLER
The LOW PASS controller is without function in this operation mode.
SUB SONIC CONTROLLER
The SUB SONIC controller is without function in this operation mode.
PHASE CONTROLLER
The PHASE SHIFT controller is without function in this operation mode.
INTERCONNECTION EXAMPLE: FULL-Mode with 1 Subwoofer
Connect stereo RCA output
(SUB OUT) of the headunit with
LINE INPUT R/L of the amplifier
R
L
Subwoofer
1 – 8 Ohms
Switch position = MASTER
An additional subwoofer can be
connected to the non-occupied
speaker outputs. In this case
ensure an impedance of 2 - 8
ohms per subwoofer.
HINWEIS!
FULL RANGE MODE
The FULL mode is only meaningful with a subwoofer, if your headunit is equipped with an separate suwboofer lineout and the audiosignal
is already modfied by the headunit filters like lowpass, subsonic and phase. In the FULL mode the filter functions of the amplifier wil be
bypassed and this avoids a additional filter modification of the audio signal, because the signal of the headunit is already modified.
Please check the operation manual of your headunit.
Switch position = FULL
24

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hifonics X4-Atlas bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hifonics X4-Atlas in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 3,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info