535965
8
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
• Do not use any cleaning agents or chemical solvents when cleaning, as these could damage the
surface of the device.
• Repairsmustalwaysbeconductedbyqualifiedspecialists,asyoumightotherwisebeexposedto
dangerous high voltage levels or other hazards.
GENERAL NOTES ON CONNECTING YOUR HECO SATELLITE SPEAKERS
The connectors are located at the rear of the satellite speakers. They are equipped with a clamping
mechanism for cables cross-sections of up to 2.5 mm². To connect the satellites, please use normally
available 2 x 0.75 mm² – 2 x 2.5 mm² loudspeaker cables.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables. Place
the loudspeakers in their planned positions and cut the cables to the right length.
Strip 10 – 15 mm of insulation from the ends of the cables. Twist the ends – this is much better than tin-
ning them with solder – insert them in the terminals and tighten the terminal screws firmly (fig. 1). Loud-
speaker cables with CE-compliant banana or single-pin plugs (4 mm) or forked fittings can also be used.
For good sound it is imperative that the cables must be connected in such a way that the speakers are
“in phase”. This means that the black negative terminals on the speakers (-) must be connected to the
negative (-) terminals on the amplifier, the red positive (+) speaker terminals to the positive (+) amplifier
terminals. To make this easier one wire of most speaker cables is marked with a coloured strip or a ridge
in the insulation.
Before switching on the system double-check all your connections and make sure that the terminal
screws are tight and that there are no short circuits caused by stray wire filaments – this could cause
serious damage to your amplifier!
WALL-MOUNTING
A mounting plate and thread (1/4” US20) are located at the rear for attaching standard wall brackets.
Important information/safety instructions:The customer is solely responsible for the use of wall brack-
ets / speakers attachments. The customer is also solely responsible for the secure attachment of the
speaker bracket to the wall and the selection of suitable mounting material (e.g. screws, wall plugs, etc.),
while taking account of the weight and construction of the speaker and the condition of the wall.
POSITIONING
The centre, front and rear loudspeakers are marked on the back. The satellite connected to the centre
output should be positioned on top of or beneath your TV set. The front satellites are placed to the left
and the right of the TV set, preferably at equal distance and at ear-height. The satellites connected to
the rear/surround outputs should be located to the left and right behind the listening position and slightly
above ear-height.
Placement of the subwoofer is generally not critical. It should, if possible, be located near the front
satellites.
CONNECTION TO AN AV RECEIVER
Connection of the system to an AV receiver is shown in figure 2.
Note: In the receiver set-up, the front, centre, and rear loudspeaker channels should be set to ‘small’.
Some receivers also provide the option of setting the cross-over frequency between the subwoofer and
satellites. If this is the case, please set this frequency to 150 Hz or the frequency that comes closest to
150 Hz. Please consult the user manual supplied with your receiver.
GBGB
8
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Heco MUSIC COLORS CINEMA 5.1A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Heco MUSIC COLORS CINEMA 5.1A in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Zweeds als bijlage per email.

De handleiding is 1,59 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info