721496
9
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
8
Keep at hand suitable crossed screwdriver, adjustable
spanners, pliers and wrenches. Before assembly, make
sure all protection packing material has been removed.
Flexible gas hose(1763-1) and clamps (if necessary) are
supplied with this appliance and must be used, according
to National Rules in force. You need to purchase one gas
regulator and one gas cylinder. The gas regulator has to
be set according to specific gas category (see on page
2) and proper gas consumption (g/h) specification. The
LPG cylinder should be standard one. Recommend to use
Less than 10kg. Replacement must be that specified in
“Gas Requirements” section of this Instruction Manual. Be
careful: do not kink flexible gas rubber pipe of gas circuit. If
pipe holder should not be provided, thread of the gas inlet
connection will be in line with Standards ISO 7-1 or ISO
228-1, according to National Rules in force of the country
of destination.
Make sure appliance gas knob is turned “OFF” (full
disk) before assembling
Connect the hose to the appliance and the regulator.
Tighten the screw of the hose clamp with a screwdriver.
Connect the regulator to LPG cylinder by hand. And
Hand tighten only.
Connecting gas circuit to LPG cylinder
Protect appliance from wind during lighting and operation.
TURN ON THE HEATER
Push and turn the control Knob to , and
‘click’ will be heard.
TURN OFF THE HEATER
Push and turn the control Knob to OFF, and
‘click’ will be heard.
Heater Lighting Instructions
Never test for leaks with an open flame. Prior to first
use, at the beginning of each season, or every time
your LP Gas Cylinder is changed, you must check for
gas leaks. Follow these three steps:
Make a soap solution by mixing one part 1.
liquid detergent and four parts water.
Turn the heater Control Knob to the full OFF 2.
position, then turn on gas at source.
Apply the soap solution to all visible gas 3.
connections. If bubbles appear in the soap
solution the connections are not properly
sealed. Check each fitting and tighten or repair
as necessary.
If necessary, substitute gasket (according to EN 4.
549 Class B2) or material used to guarantee
tightness (according to EN 751-1 Class I)
Check for Gas Leaks
4 parts water
1 part liquid detergent
Set Control Knob to OFF and open the LP Gas Cylinder
valve.
Push and turn the control knob to . This will trigger a
spark to ignite the pilot burner. 3 to 4 attempts may be
required.
Once the pilot flame is established, keep pressing
the knob for 10 seconds to ensure that the burner
remains lit.
If the burner does not ignite, turn gas off at source
and turn Control Knob OFF. Wait at least 5 minutes for
gas to clear, then retry. If your heater still fails to light,
turn the Control Knob and gas source OFF. Refer to the
instruction manual “Lighting Your Heater Using A
Match” and “Trouble Shooting”for further informa-
tion.
When the heater is not in use, turn the control knob to
OFF and turn off the gas source.
Disconnect and remove the gas cylinder before storing
this gas heater indoors.
ENGLISH
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Heatstrip Gas bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Heatstrip Gas in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Deens als bijlage per email.

De handleiding is 3,42 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info