Quality agreement
WARRANTY CLAIM — YES OR NO?
Rust: To provide a proper basic protection of the chassis, it has under-
gone a rust-proofing treatment. However, rust-stains may be found when
lacking maintenance. This case will not be covered by the warranty.
Scratches: Scratches caused by wear and tear will not be covered by
the warranty.
Mould formation: Fabric parts, having become wet, should be dried
properly to prevent mould formation (see Instructions). Mould formation
will not be covered by the warranty.
Bleaching of the fabrics: We confirm that the fabrics comply with the
established standards. It cannot be ruled out that colours of the fabrics
may fade while the parts are exposed to direct sunlight, washed too
frequently, come into contact with sweat and detergents, or suffer
abrasive wear (especially on those parts where the pram is handled).
Consequently, colour fading is excluded from the warranty. It is un-
avoidable that colours sometimes differ slightly from one individual batch
to the next, which is why this case will not be covered under the warranty.
Knob formation on fabrics: We recommend that you apply general clo-
thes care. As with woollen sweaters, the knobs can easily be removed by
using a clothes-brush or burling machine.
Tearing of seams, fabrics, press studs: At the time of purchase, please
check carefully that all the fabric parts, seams and snap fasteners
have properly been sewn and fastened. In case of a possible complaint
concerning seams/defective snap fasteners, a claim must immediately
be reported to your dealer after the defect has been discovered.
Wheels: As wheels used on prams will not be balanced, they may show
slight run-outs ("wobbles"). Worn tires will be regarded as natural wear and
tear. No claim can be raised if your pram, using pneumatic tired wheels,
has a "flat". This will be attributed to extraneous causes — a small hole
caused by a pointed object, or pushing the pram about when it has not
got enough air in the tire. This case will not be covered by the warranty.
17
