502813
7
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
Rear Panel Connections
Using the Reference Card supplied with
this manual, use this section as a quick
guide to the connections required to
install the PT2500. For complete instal-
lation and set up instructions, see pages
7-10.
¡ Phono Input: Connect the output
of a turntable or tone arm to these
jacks.
System Ground Terminal: To
reduce hum and noise, connect the
ground lead from your turntable or
tone arm to this terminal.
£ Aux Input: Connect the outputs
of any audio source to these jacks.
¢ CD Input: Connect the outputs of
a CD player or external D/A convert-
er to these jacks.
Tape 1 Input: Connect the
PLAY/OUT jacks of an audio tape
recorder to these jacks.
§ Tape 1 Output: Connect the
RECORD/INPUT jacks of an audio
tape recorder to these jacks.
Tape 2 Input: Connect the
PLAY/OUT jacks of a second audio
tape recorder to these jacks.
Tape 2 Monitor Output: Connect
the RECORD/INPUT jacks of a sec-
ond audio tape recorder to these
jacks.
ª VCR1 A/V Inputs: Connect the
audio and video PLAY/OUT jacks of
a VCR to these jacks.
VCR1 A/V Outputs: Connect the
audio and video record RECORD/IN
jacks of a VCR to these jacks.
VCR2 A/V Inputs: Connect the
audio and video PLAY/OUT jacks of
a second VCR, or another A/V
source such as a satellite receiver to
these jacks.
¤ VDP A/V Inputs: Connect the
audio and video outputs of a laser
disc or DVD player to these jacks.
Video Monitor Outputs:
Connect these jacks to the video
input of a TV or video projector.
Remote Amplifier Trigger:
Using the accessory cable supplied
with the PT2500, connect this jack to
compatible products such as the
PA5800 for automatic turn on/off
operation.
AC Power Cord: Connect this
plug to an unswitched, wall mounted
AC outlet.
Unswitched Accessory AC
Power Outlet: This outlet provides
AC power that may used with any AC
device up to 100 watts. The power
will remain on at this outlet regardless
of whether the PT2500 is on or off.
Switched Accessory AC Power
Outlet: This outlet provides AC
power to connected products only
when the PT2500 is turned on. Note
that the total current draw of the
products may not exceed 100 watts.
° Remote Control Extension
Output: This jack may be connect-
ed to other compatible Harman
Kardon products so that they will
receive infrared commands cap-
tured by the PT2500’s remote sen-
sor.
· Remote Control Extension Input:
If the PT2500’s front panel IR sensor
is blocked due to cabinet doors or
other obstructions, an external IR
sensor may be used. Connect the
output of the sensor to this jack.
a Surround Channel Outputs:
Connect these jacks to the surround
channel inputs of a power amplifier
or digital audio processor with pass
through capability.
b Center Channel Outputs:
Connect the output of one of these
jacks to the center channel input of
a power amplifier or digital audio
processor with pass through capa-
bility.
NOTE: In most applications only one
center channel connection will be
required. The output of both jacks is
identical, and either jack may be
used for system connections.
c Front Channel Outputs:
Connect these jacks to the front
left/right channel inputs of a power
amplifier or digital audio processor
with pass through capability.
d Subwoofer Outputs: Connect
these jacks to the line level input of a
powered subwoofer, or to the inputs
of a subwoofer amplifier.
NOTE: This output is a full range
left/right signal. For proper operation
BOTH jacks must be connected to
the left/right inputs of a powered
subwoofer, or a “Y” cable must be
used to connect the two outputs
together if a single input mono sub-
woofer is used.
WARNING: Since this is a full range
output, the signal must be sent
through a crossover or low pass filter
before being used with a passive
subwoofer or other speaker that
does not contain a built in crossover.
e AM Antenna Input: Connect the
AM loop antenna supplied with the
PT2500 to these terminals. An exter-
nal AM antenna may also be con-
nected here.
f FM Antenna Input: Connect an
FM antenna to these terminals. Note
that a 300 ohm to 75 ohm adapter is
required for connections from twin
lead dipole antennas.
5
PT2500 rev (G) 10/23/96
•PT2500(g).qx 10/23/96 7:36 AM Page 6
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon PT2500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon PT2500 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,47 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info