FRONT-PANEL CONTROLS
1 Standby/On Indicator
2 Standby/On Button
3 Surround Mode Group Selector
4 Surround Mode Selector
5 Tuning Selector
6 Tuner Band Selector
7 Preset Station Selector
8 Input Source Selector
9 Tuning Mode Selector
) Set Button
! ¤/⁄ Buttons
@ Front-Panel Control Door
# Volume Control
$ Input Indicators
% Speaker/Channel Input Indicators
^ Upper Display Line
& Lower Display Line
* Surround Mode Indicators
( Remote Sensor Window
FRONT-PANEL CONTROLS
FRONT-PANEL CONTROLS 55
The following controls and indicators are available on the DPR 1005’s front panel:
The following controls and jacks are located behind the front-panel door. To open the door, press the center of the door and gently swing it down towards you.
A Main Power Switch
B Tone Mode Button
C Speaker Selector Button
D Channel Adjust Selector
E Digital Input Selector
F Delay Adjust Selector
G Headphone Jack
H Optical 3 Digital Input
I Input/Output Indicator
J Coaxial 3 Digital Input
K Video 5 Audio/Video Jacks
1 Standby/On Indicator: This indicator is amber
when the DPR is in the Standby mode to signal that the
unit is connected to an AC power source and is ready
to be put into operation. When the unit is in use, the
indicator turns blue.
2 Standby/On Button: When the Main Power
Switch
A
is “ON,” press this button to turn on the
DPR 1005; press it again to turn the unit off.
3 Surround Mode Group Selector: Press this but-
ton to select the top-level group of surround modes.
Each press of the button will select one of the sur-
round mode categories. Once the button is pressed so
that the name of the desired surround mode category
appears in the on-screen display and in the
Lower
Display Line
&, press the Surround Mode
Selector
4 to cycle through the individual modes
available. For example, press this button to select Dolby
modes, and then press the
Surround Mode Selector
4 to choose from the various mode options.
4 Surround Mode Selector: Press this button
to select from among the available surround mode
options for the surround mode category selected.
The specific modes will vary based on the number of
speakers available, the surround mode category and
whether the input source is digital or analog. For exam-
ple, press the
Surround Mode Group Selector 3
NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at
www.harmankardon.com.
