Installation and Setup
System Installation
After unpacking the unit, and placing it
on a solid surface capable of supporting
its weight, you will need to make the
connections to your audio and video
equipment. These steps need to be done
only when the receiver is first installed,
or when a change is made to the input
source equipment.
Audio Input and Output Connections
We recommend that you use high-quality
cables when making connections to
source equipment and recorders to
preserve the quality of the signals.
When making connections to audio
source equipment or speakers it is always
a good practice to unplug the unit from
the AC wall plug. This prevents any possi-
bility of accidentally sending audio or
transient signals to the speakers that may
damage them.
1. For playback-only audio sources, such
as a CD player, CD changer, tape deck or
phono cartridge, connect the output
jacks of the player to the appropriately
labeled inputs on the rear panel
de.
NOTE: When the source device has both
fixed and variable audio outputs it is best
to use the fixed output unless you find
that the input to the receiver is so low
that the sound is noisy, or high that the
signal is distorted.
2. If a turntable is connected to the
Phono input e, connect the ground
wire from the cartridge or tone arm to
the Ground terminal §.
3. When connecting audio recording
devices such as cassette recorders, open
reel audio tape decks, DAT or MD, con-
nect the PLAY/OUT jacks of the recorder
to the
Play jacks ª⁄on the AVR55.
Connect the RECORD/IN jacks on the
recorder to the Tape Rec jacks •‚
on the AVR55.
4. Connect the output of any digital
sources to be used to the appropriate
connections on the AVR55 rear panel.
The Optical and Coaxial digital inputs
¶fmay be used with either a Dolby
Digital (AC-3) source or the output of a
conventional CD or LV player’s PCM
(S/P-DIF) output. The AC-3 RF input
g may ONLY be connected to the special
AC-3 RF output of a laser disc player.
5. Assemble the AM Loop Antenna sup-
plied with the unit as shown below.
Connect it to the AM and GND screw
terminals
¡.
6. Connect an FM antenna to the
FM (75 ohm) connection ™. The
FM antenna may be an external roof
antenna, an inside powered or wire lead
antenna, or a connection from a cable
TV system. Note that if the antenna or
connection uses 300-ohm twin lead
cable, you must use the 300-ohm to
75-ohm adapter supplied with the unit
to make the connection.
7. Connect the front, center and surround
speaker outputs fi to the respective
speakers.
To assure that all the audio signals are
carried to your speakers without loss of
clarity or resolution, we suggest that you
use high-quality speaker cable. Many
brands of cable are available, and the
choice of cable may be influenced by the
distance between your speakers and this
receiver, the type of speakers you use,
personal preferences and other factors.
Your dealer or installer is a valuable
resource to consult in selecting the
proper cable.
Regardless of the brand of cable selected,
we recommend that you use a cable con-
structed of fine, multistrand copper with
a gauge of 14 or smaller. Remember that
in specifying cable, the lower the gauge
number, the thicker the cable.
Cables that are run inside walls should
have the appropriate markings to indicate
listing with UL, CSA or other appropriate
testing agency standards. Questions about
running cables inside walls should be
referred to your installer or a licensed
electrical contractor who is familiar with
the NEC and/or the applicable local
building codes in your area.
16
