15 INSTALLATION AND CONNECTIONS
Installation and Connections
2. Connect the analog audio and video outputs
of a satellite receiver, cable TV converter or
television set or any other video source to the
Video 2 or Video 3 Jacks bcfg.
3. Connect the analog audio and video
outputs of a DVD or laser disc player to the
DVD Jacks §⁄. When a digital audio con-
nection is used for your DVD player, the
default connection is the
Coaxial Digital
Input 1 Jack
e. However, the connection
may also be made to any of the
Optical d#
or Coaxial e$ Digital Inputs, provided
that the digital input source selection is
changed as shown on page 23.
4. Connect the digital audio outputs of a DVD
player, satellite receiver, cable box or HDTV con-
verter to the appropriate
Optical or Coaxial
Digital Inputs
de#$.
5. Connect the
Video Monitor Output ¤
jacks on the receiver to the composite or
S-Video input of your television monitor or
video projector.
Video Connection Note:
• Composite and S-Video signals may only be
viewed in their native formats.
Power Connections
This unit is equipped with two accessory AC
outlets. They may be used to power accessory
devices, but they should not be used with high-
current draw equipment such as power ampli-
fiers. The total power draw to each outlet may
not exceed 100 watts.
The
Switched AC Accessory Outlet fl will
receive power only when the unit is on. This is
recommended for devices that have no power
switch or a mechanical power switch that may
be left in the “ON” position.
NOTE: Many audio and video products go into
a Standby mode when they are used with
switched outlets, and cannot be fully turned on
using the outlet alone without a remote control
command.
The
Unswitched AC Accessory Outlet ‡
will receive power as long as the unit is
plugged into a powered AC outlet.
Finally, when all connections are complete,
plug the
Power Cord ° into a nonswitched
120-volt AC wall outlet. You’re almost ready to
enjoy the AVR 120!
