502640
6
Verklein
Vergroot
Pagina terug
1/19
Pagina verder
4
Front Panel Controls
ENGLISH
1. POWER BUTTON
Press this button to turn the power
on. Press again to turn the power off
(Stand by). If you connect the other
components to the switched outlet, it
can also be used as a system power
button.
2. HEADPHONE JACK
Stereo headphones can be plugged
into this jack for private listening.
Headphone impedance should be
between 8 ohms and 2K ohms with
best results between 200 and 400
ohms.
3. BASS CONTROL
Modifies the low-frequency sound of
the left and right channels as much as
±10dB. Set this control at a suitable
position for your taste and room
acoustics.
4. TREBLE CONTROL
Modifies the high-frequency sound of
the left and right channels as much as
±10dB. Set this control at a suitable
position for your taste and room
acoustics.
5.BALANCE CONTROL
This control is used for balancing the
relative sound volume of the left and
right channel speakers. Clockwise
rotation reduces the volume from the
left speaker, counterclockwise
rotation reduces the volume from the
right speaker.
6. SURROUND
MODE SELECTOR
Press this button to select the desired
surround mode. The mode is
changed between normal DOLBY
Pro-Logic and DOLBY 3-STEREO.
7. BYPASS SELECTOR
Defeats all surround modes.
8. INPUT FUNCTION
SELECTOR BUTTONS
Press these buttons to select the
desired input source.
9. TAPE MONITOR BUTTON
Press this button to select input from
a tape deck and listen to its monitor
function (with 3 head decks).
10. VCR2 INPUT JACKS
Connect these jacks to the
corresponding output jacks of a VCR
or Camcorder (only playback)
(Yellow: Video, Red/White: Audio).
11. TUNE / PRESET
UP/DOWN BUTTONS
When PRESET and AUTO is not lit,
the Tune/Preset UP/DOWN buttons
will allow you to tune to a station
manually.
12. TUNE / PRESET BUTTON
Press this Tune/Preset button to light
up the preset mode then use the
up/down buttons (11) momentarily to
scan the preset station frequencies.
The receiver stops at each preset
location from 1-30 that has been
entered in memory. Hold the buttons
(11) down to skip through the presets
quickly. In the TUNE mode (selected
by the TUNE/PRESET button (12))
press these buttons to change
selected frequencies.
13. MEMORY BUTTON
Use this button to store an AM or FM
frequency. Press this button and
select one of 30 preset locations to
store the frequency with the UP /
DOWN buttons while the memory
indicator blinks, press MEMORY
again to store preset station.
NOTE: When you store a frequency in
a memory location that already
contains a frequency, you replace the
previous frequency. If your receiver is
disconnected from AC power for
more than about 2 weeks, it loses all
stored frequencies.
14. SEEK STEREO BUTTON
Press this button, “Auto” will
illuminate in the display. Then press
the uP or DOWN button. The tuner
will automatically seek for stations
upwards or downwards in your area
that have enough signal strength to
be listenable. The tuner will stop on
stations until the Seek Stereo button
is pressed again.
15. VOLUME CONTROL
Turn the VOLUME clockwise to
increase the volume and
counterclockwise to decrease it. The
volume of the front, center, and rear
channels is changed at the same
time.
16. DISPLAY WINDOW
This window shows the state of
operation for easier control of the
receiver. It also contains the IR
Remote Sensor.
AVR10 engelsk 11/01/98 10:10 Side 4
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon AVR10 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon AVR10 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,53 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info