640739
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
NOTE
If another accessory is already using the accessory circuit
connector [4], use a Switched Circuit Adapter Harness (Part
No. 70264-94A, available separately) as a "Y" adapter.
6. Mate the heated seat connector to the accessory circuit
connector [4].
7. Follow the instructions in the Owner's Manual to re-connect
the negative (-) battery cable.
8. Guide the wiring into the space beneath the seat so that
the wiring will not be crimped when the seat is installed.
9. Follow the instructions in the Owner's Manual to install the
seat.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
10. For 1997 through 2005 FLHT/I/C/CI/CUI models: Pro-
ceed to the OPERATION section.
For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR
models:
a. See Figure 2. Obtain the new passenger grab strap
(1) from the kit, and the saddlebag front mounting
brackets (4), bolts (3) and flat washers (2) removed
earlier.
b. Install the saddlebag front mounting brackets and
grab strap as shown to the chrome frame tube covers.
Finger-tighten the bolts.
c. Follow the instructions in the Owner's Manual to re-
install the left-side and right-side saddlebags.
d. Tighten the mounting bolts to 60-96 in-lbs (7-11 Nm)
after seating the saddlebags.
2
3
1
4
is01041
1. Passenger grab strap
2. Original equipment flat washer
3. Original equipment hex head bolt
4. Forward saddlebag mounting bracket
Figure 2. Grab Strap and Saddlebag Front Mounting
Bracket
OPERATION
NOTE
The accessory switch is a rocker switch found on the inner
fairing switch panel.
1. With the ignition/key switch at IGNITION or ACCESS,
open the circuit to the heated seat by flipping the
accessory switch from OFF to ON.
2. Two switches on the side of the seat control the rider and
passenger heating areas independently. The forward
switch controls the rider area, and the rearward switch
controls the passenger area.
a. In the center position, the heat to that area of the seat
is OFF.
b. Pressing the lower part of the switch in toward the
seat turns the heat in that area ON at the LOW set-
ting.
c. Pressing the upper part of the switch in toward the
seat turns the heat in that area ON at the HIGH set-
ting.
NOTES
If the accessory switch is left ON and a seat heater rocker
switch is left in either the LOW or HIGH position when the
motorcycle is turned off, the seat will begin heating when the
ignition/ key switch is turned to the IGNITION or ACCESS
position.
A seat heater in operation while the motorcycle engine is
turned off or running below normal operating speed can
quickly discharge the vehicle battery, which could lead to
a subsequent failure to start, and could damage the elec-
trical system.
1
3
2
4
is01042
1. Rider section heat control switch
2. Passenger section heat control switch
3. Low heat position
4. High heat position
Figure 3. Seat Heating Control Switches
-J03893 2 of 2
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harley-Davidson J03893 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harley-Davidson J03893 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info