12 13
11
Feed the top straps through the top set of cambuckles.
WARNING: ENSURE THAT THE STRAPS ARE
INSERTED THROUGH THE CAMBUCKLES IN THE
CORRECT DIRECTION.
Tighten the upper straps so that the carrier is resting on
the tailgate and supported approximately 50mm
(2 inches) above the upper face of the bumper.
.
Position the lower strap chassis hooks to an appropriate
location under the car for example; towing eye, steel
chassis section or bumper support.
Note: It is vital that you use a strong metal location to
secure these chassis hooks. Ensure the webbing straps
do not touch the vehicle exhaust.
Progressively tighten each lower strap alternatively.
Position the side panel hooks on the edges of the
tailgate/boot. Progressively tighten each side strap
alternately. Re-tension all straps securing the carrier to
the vehicle until the carrier is fully secure. Check that
there is still sufficient clearance between the carrier frame
and the vehicle bodywork, typically a minimum of 5cm (2
inches) is acceptable. It maybe necessary to readjust the
angles of the carrier support tubes to increase the
clearance. Note: the 50mm bumper clearance as defined
in step 9 will reduce as the straps are fully tensioned. This
is acceptable as long as clearance is maintained from the
bumper
Position your cycle(s) into the saddle area of the frame
locator. Pass the webbing strap over the frame of the
cycle and thread through the metal loop. Pull the strap
back tightly and press the hook and loop fastener to
secure.
Note: there must be a minimum 45mm of overlap (See
Diagram). The straps supplied with this product are
suitable for cycle frames up to 40mm in diameter. For
larger frames, longer straps are available as an
accessory.
Stand back from your vehicle and check that the lights
and number plate are not obscured. If the lights or
number plate are still obscured, to comply with road and
traffic regulations, a lighting board must be used.
IMPORTANT: Using the fitted RED webbing straps,
secure the first cycle to the carrier main frame. Failure
to use these straps will result in the cycles falling off the
carrier.
14
When carrying a second or third cycle, feed the RED
straps around all cycles, and fully tighten. Failure to use
these straps will result in the cycles falling off the carrier.
To reduce obstruction from the handle bars alternate the
direction of each cycle during loading.
15
The cycle frame locators can be adjusted to best suit the
angle of ladies’, full suspension and children’s etc cycle
frames. A False Crossbar is available as an accessory for
the easy mounting of these differing frame styles.
IMPORTANT:
• Re-tighten all cycle carrier-webbing straps after
loading the cycle(s).
• Do not open your boot/tailgate with the panel
hooks/dumbbells in position.
• For ease of storage the cycle carrier may be folded
flat by loosening all six ratchet adjusters.
• When re-assembling the carrier to your vehicle, it is
important to fully tighten the ratchet adjusters on the
lower support tube first.
8
