683782
6
Verklein
Vergroot
Pagina terug
1/38
Pagina verder
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Scrubmaster B140 R
The Scrubmaster B140 R
Scrubmaster is packed in a cardboard
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hako Scrubmaster B140R bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hako Scrubmaster B140R in de taal/talen: Engels als bijlage per email.

De handleiding is 1,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info