711005
11
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
21
Troubleshooting
Troubleshooting without display code
Problem Cause Solution
Washing machine Programme is not yet started. Press “Start/Pause“ button.
fails to operate. Door is not properly closed. Close the door properly.
Machine has not been switched on. Switch the machine on.
Power failure. Check power supply.
Washing machine No chosen programme. Set programme and start it.
will not be filled No water. Check water tap.
with water. Inlet hose is kniked. Check inlet hose.
Inlet hose filter is blocked. Unblock inlet hose filter.
Water pressure is less than Check water pressure.
0,03 MPa.
Water supply failure. Ensure the water supply.
Machine is draining Height of drain hose is Make sure that drain hose
while being filled below 80 cm. is properly installed.
Drain hose end could
reach into water.
lever
In case of power failure
The current programme and its setting will be saved only
sitratselcycemmargorpwenaylbaborP.emittrohsarof
needed.
If a power failure cuts an operating wash programme door
opening is mechanically blocked.To get out any laundry
water level should not be seen in the glassy porthole of the
door - danger of burns!
Not till then pull lever beneath service flap until door is
unlocked by a gentle click.Afterwards refix all parts.
20
Troubleshooting
Display code
noituloSesuaCedoC
Auto
AL-1
/AL-2
/AL-3
/AL-4
Automatic
Weighing the laundry load in
the drum.
load detection.
Laundry weight detection in progress, please
wait until program cycle time is displayed.
Please wait until program cycle time is
displayed: AL-1 = small load;AL-2 = half load;
AL-3 = optimized weight load;
AL-4 = full load.
1:25 Remaining wash cycle time. Refer to additional symbol.
19:30 Remaining wash cycle time. End is likely delayed - refer to symbol.
Lock
Door cannot be opened due to
water level or hot water in the
drum.
Wait to the end of program or cancel the
program and select the drain program. In
case of hot water is in the drum, to avoid
scalding, select a handwash program and
wash several minutes and then select a
draining program before open the door.
End End of cycle.
E1 Drainage error, water not emptied Clean pump filter.
Check drain hose for blockage
and proper
installation.
E2 Lock - error. Shut the door properly.
E4 Water level not reached after 8
minutes.
Check if water supply
and water pressure
is normal.
Drain hose is self-syphoning.
E8 Water protective level - error. Auto release.Otherwise contact the
After sales service.
F3 Temperature sensor - error. Contact the After sales service.
F4 Heating error (Appears at the end of
a cycle .)
Contact the After sales service.
F7 Motor - error. Contact theAfter sales service.
FA Water level sensor error. Contact theAfter sales service.
FC Electronic control - error. Contact theAfter sales service.
Unb Unbalanced load and not able to
spin.
Check and balance the laundry load in the
drum. Also reduce the load if too heavy.
Restart with a spin program.
within 6 minutes.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Haier HW100-BD14756 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Haier HW100-BD14756 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,93 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Haier HW100-BD14756

Haier HW100-BD14756 Gebruiksaanwijzing - Deutsch - 38 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info