No. Control feature Function and application CM-1 transmitter
6 Stand Fould-out stand
7 Frequency
There is a slide switch on the back of the device for setting
selector switch the following 3 frequency ranges:
Switch A 863,500 MHz
setting B 864,000 MHz
C 864,500 MHz
Slide the selector switch to the required frequency position
using the supplied pin.
Bear in mind at all times that the
CM-1
transmitter and
the
CM-1
receiver have to be set to the same frequency
ranges. Different frequency ranges prevent each trans-
mission.
8 Battery compart- The battery compartment is located on the back of the
ment cover device and holds both batteries.
9 Recording Insert the knob of the pendant cord into the circular part
device
of the device and engage the knob perceptibly by pushing
pendant cord
it towards
he tip of the device.
Inserting the batteries into the CM-1 transmitter:
The device runs on two rechargeable "AAA"-type batteries. Where necessary,
only use original replacement batteries.
It can also run on non-rechargeable batteries. If you run your
CM-1
communica-
tion system on disposable batteries, don't place the transmitter onto the CM
charger.
English 31
